Bedienungsanleitung Pioneer CD-R55 (Seite 1 von 4) (Englisch, Französisch)

41209

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Owner’s Manual

Mode d’emploi

Remote control

Télécommande

CD-R55

PIONEER CORPORATION

4-1, MEGURO 1-CHOME, MEGURO-KU

TOKYO 153-8654, JAPAN

PIONEER ELECTRONICS (USA) INC.

P.O. Box 1540, Long Beach, California 90801-1540, U.S.A.

TEL: (800) 421-1404

PIONEER EUROPE NV

Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium

TEL: (0) 3/570.05.11

PIONEER ELECTRONICS ASIACENTRE PTE. LTD.

253 Alexandra Road, #04-01, Singapore 159936

TEL: 65-6472-7555

PIONEER ELECTRONICS AUSTRALIA PTY. LTD.

178-184 Boundary Road, Braeside, Victoria 3195, Australia

TEL: (03) 9586-6300

PIONEER ELECTRONICS OF CANADA, INC.

300 Allstate Parkway, Markham, Ontario L3R OP2, Canada

TEL: 1-877-283-5901

PIONEER ELECTRONICS DE MEXICO, S.A. de C.V.

Blvd.Manuel Avila Camacho 138 10 piso

Col.Lomas de Chapultepec, Mexico, D.F. 11000

TEL: 55-9178-4270

先鋒股份有限公司

總公司 : 台北市中山北路二段44號13樓

電話 : (02) 2521-3588

先鋒電子（香港）有限公司

香港九龍尖沙咀海港城世界商業中心

9樓901-6室

電話 : (0852) 2848-6488

Published by Pioneer Corporation.

Publié par Pioneer Corporation. Copyright

droits réservés.

Printed in China

Imprimé en Chine

<CZR5072-A> E

If you want to dispose this product, do not mix it

with general household waste. There is a sepa-

rate collection system for used electronic pro-

ducts in accordance with legislation that requires

proper treatment, recovery and recycling.

Private households in the 25 member states of

the EU, in Switzerland and Norway may return

their used electronic products free of charge

to designated collection facilities or to a retai-

ler (if you purchase a similar new one).

For countries not mentioned above, please

contact your local authorities for the correct

method of disposal.

By doing so you will ensure that your disposed

product undergoes the necessary treatment,

recovery and recycling and thus prevent po-

tential negative effects on the environment

and human health.

Information to User

Alteration or modifications carried out without

appropriate authorization may invalidate the

user’s right to operate the equipment.

This device complies with part 15 of the FCC

Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interfer-

ence, and (2) this device must accept any inter-

ference received, including interference that

may cause undesired operation.

Use and care of the remote

control

Installing the battery (Fig. 1)

Slide the tray out on the back of the remote con-

trol and insert the battery with the plus (+) and

minus (–) poles pointing in the proper direction

! When using for the first time, pull out the

film protruding from the tray.

WARNING

! Handling the cord on this product or cords as-

sociated with accessories sold with the pro-

duct may expose you to chemicals listed on

proposition 65 known to the State of California

and other governmental entities to cause can-

cer and birth defects or other reproductive

harm. Wash hands after handling.

! Keep the battery out of the reach of children.

Should the battery be swallowed, immediately

consult a doctor.

CAUTION

! Do not allow this unit to come into contact

with liquids. Electrical shock could result.

Also, this unit damage, smoke, and overheat

could result from contact with liquids.

! Do not disassemble or modify this unit. To do

so may cause a malfunction.

! Always keep the volume low enough so that

you can hear sounds from outside the vehicle.

! Use only one CR2025 (3 V) lithium battery.

! Always check carefully that you are loading

the battery with its plus (+) and minus (–)

poles facing in the proper directions.

! Remove the battery if the remote control is not

used for a month or longer.

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type.

! Do not handle the battery with metallic tools.

Do not store the battery with metallic materials.

! In the event of battery leakage, wipe the re-

mote control completely clean and install a

new battery.

! When disposing of used batteries, please

comply with governmental regulations or en-

vironmental public institutions’ rules that

apply in your country/area.

“Perchlorate Material – special handling may apply.

See

www.dtsc.ca.gov/hazardouswaste/perchlorate.

(Applicable to California, U.S.A.)”

Using the remote control

Point the remote control in the direction of the

front panel to operate.

Before You Start

! The remote control may not function prop-

erly in direct sunlight.

Important

! Do not store the remote control in high tem-

peratures or direct sunlight.

! Do not let the remote control fall onto the

floor, where it may become jammed under the

brake or accelerator pedal.

Using the remote control

operation mode switch

There are three remote control operation

modes on the remote control.

AVH mode operation

When operating an AV Receiver (e.g., AVH-

P5900DVD) with this remote control, the mode

is normally switched to AVH.

DVD mode operation

When operating a Pioneer DVD player (e.g.,

XDV-P6) with this remote control, the mode is

switched to DVD. If you switch the mode to

DVD, the joystick and 0 to 10 operations are

changed for DVD player.

TV mode operation

When operating a Pioneer TV tuner (e.g., GEX-

P5700TV (P)) with this remote control, the

mode is switched to TV. If you switch the

mode to TV, the joystick operation is changed

for TV tuner.

In TV

mode, only buttons shown below can be used.

! SOURCE button

! ATT button

! VOLUME buttons

! Joystick

! DIRECT button

! REAR SOURCE button

Setting remote control

code type

When the remote control operation mode switch is

set to DVD, changing the remote control code type

enables you to operate the Pioneer DVD player with

this remote control. There are three remote codes,

code type A, code type B and code type AVH.

! When operating an AV Receiver (e.g., AVH-

P5900DVD), select code AVH.

! When operating a multi-DVD player (e.g.,

XDV-P6), select code A.

! When operating a DVD navigation unit, se-

lect code B.

1 Set the remote control selection switch

on the left side of the remote control to

the appropriate position with a pen tip or

other pointed instrument .

! If you select AVH mode, there is no need to

take the following procedure.

! If you select A/B mode, take the following

procedure and change the code type to the

appropriate type.

2 Press 0 and CLEAR on the remote con-

trol simultaneously to change the code

type.

Initially, the code type is set to A. Each time

you press 0 and CLEAR simultaneously on the

remote control the code type switches be-

tween A and B.

Specifications

Power source ............................. 3 V DC (Lithium battery;

CR2025)

Dimensions (W × H × D) ...54 × 149 × 13 mm

(2-1/8 × 5-7/8 × 1/2 in.)

Weight .......................................... 59 g (2 oz) (including bat-

tery)

Infrared remote control

Wavelength ................................. 945 nm

Output ........................................... typ; 10 mw/sr per Infrared

LED

Note

Specifications and the design are subject to pos-

sible modifications without notice due to im-

provements.

Before You Start

CZR5072-A - Page1-

Pioneer CD-R55 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info