Bedienungsanleitung Pioneer DCS-575 (Seite 46 von 106) (Englisch, Französisch)

61213

Zoom out

Zoom in

Vorherige Seite

1/106

Nächste Seite

Additional information11

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is

something wrong with this component, check the points below. Sometimes the trouble may lie in

another component. Investigate the other components and electrical appliances being used. If the

trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer

authorized service center or your dealer to carry out repair work.

• If the system does not operate normally due to external effects such as static electricity,

disconnect the plug from the outlet and insert again to return to normal operating conditions.

General

Problem Remedy

The power does not turn

on, or switches off

suddenly (an error

message may be

displayed at startup).

• Wait for one minute before switching back on.

• Make sure there are no loose strands of wire touching the unit. This could cause

the system to shut off automatically.

• Check that the speakers are connected correctly.

• Make sure the voltage of the mains power source is correct for the model.

• Try reducing the volume level.

• If the problem persists, take it to your nearest Pioneer authorized service center

or your dealer for servicing.

No sound is output

when a function is

selected.

• If you’re using the line input, make sure the component is connected correctly

(see Connecting auxiliary components on page 34).

• Press MUTE on the remote control to turn muting off.

• Turn up the volume.

No sound from surround

or center speakers.

• Refer to Channel level setting on page 27 to check the speaker levels.

• When TUNER is selected, you can only hear the source in stereo.

• Check that you haven’t selected the AUTO, STEREO or VIRTUAL mode (see

Listening to your system on page 15).

• Connect the speakers properly (refer to the

Setup Guide

• If the source is 96 kHz, it will be played in stereo.

Can’t operate the remote

control.

• Replace the batteries (refer to the

Setup Guide

• Operate within 7 m, 30° of the remote sensor (refer to the

Setup Guide

• Remove any obstacles or operate from another position.

• Avoid exposing the remote sensor on the front panel to direct light.

• Check that there’s nothing mistakenly plugged into the CONTROL IN jack.

• If the system is connected to a Pioneer flat screen TV with an SR+ cable, check

that the flat screen TV is switched on. Point the remote control at the flat screen TV

in order to operate the system.

• To operate other Pioneer components, make sure that the control cable and

analog audio cable are connected.

TRAYLOCK shows in the

display and the tray can’t

be ejected.

• Press and hold  OPEN/CLOSE on the front panel for about eight seconds. Then

the tray can be opened/closed using  OPEN/CLOSE.

DCS-575_580DVD_EN.book 46 ページ２００８年２月２９日　金曜日　午後５時４３分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer DCS-575 Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer DCS-575

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info