Bedienungsanleitung Pioneer dcs fs 30 (Seite 34 von 126) (Englisch, Französisch)

371611

Zoom out

Zoom in

Vorherige Seite

1/126

Nächste Seite

Surround sound settings08

Chapter 8

Surround sound settings

Using the Sound Setup menu

From the Sound Setup menu you can access

all the surround sound settings of the system,

including channel levels, speaker distances,

dynamic range, CD Type and Sound Field

adjustment. The Auto MCACC feature

(page 17) should give you the best surround

sound setup. However you may find that by

further adjustment of the surround sound

settings you can improve the surround sound

in your listening room.

1Press

SHIFT+SETUP

and use

/

select SOUNDSET then press

ENTER

to choose

the setting you want to adjust.

The available settings are shown in the front

panel display.

2Use

/

to adjust then press

ENTER

confirm and exit.

• Note that using the Auto MCACC (page 17)

again overwrites the speaker settings.

Channel level setting (

CH LEVEL

)

Not applicable to the DCS-FS30 model

Set the relative channel levels from your main

listening position.

Use / to switch between channels in the

following order:

• L – Front left speaker

• C – Center speaker

• R – Front right speaker

• SR – Surround right speaker

• SL – Surround left speaker

• SW – Subwoofer

The channel level range is ±10 dB.

Speaker distance setting (

DISTANCE

)

Not applicable to the DCS-FS30 model

Specifies the distance from your listening

position to your speakers.

When DISTANCE appears, press ENTER, then

use / to adjust the distance, and

/ to

switch between the following speakers:

• L – Front left speaker

• C – Center speaker

• R – Front right speaker

• SR – Surround right speaker

• SL – Surround left speaker

• SW – Subwoofer

Each speaker can be adjusted between 0.1 m

and 9.0 m. The default setting is 3.0 m.

Dynamic Range Control (

D.R.C.

)

Specifies dynamic range adjustment to Dolby

Digital or some DTS soundtracks. If low level

sound or dialogue seem difficult to hear

properly, this can help by bringing up the low

level sounds, while controlling high level

peaks.

Note

1 The setup menu is exited automatically after five minutes of inactivity.

2 • The Channel level setting is not available when headphones are connected.

• The speaker volume can be adjusted at any time by using VOLUME +/– and then using / to adjust the channel levels.

When TESTTONE is selected, the test tone automatically moves from speaker to speaker in the order listed above. You should

hear the test tone at the same volume from each speaker when seated in the main listening position. Press ENTER when you’re

finished.

• Since the subwoofer produces ultra-low frequencies it may seem quieter than it actually is.

• When the speaker volume is set to 51 or more, TESTTONE cannot be selected and the channel level setting range is

restricted. In addition, if the channel level range of any speaker is set to the + side, the maximum speaker volume is also

restricted.

DCS-585-590DVD_EN.book 34 ページ２００９年３月１２日　木曜日　午前１１時２１分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer dcs fs 30 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer dcs fs 30

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info