Note:
• When this unit is installed in a vehicle without
A
red cable must be wired to the terminal that can
detect the operation of the ignition key
Otherwise, battery drain may result.
• Use this unit in other than the following condi-
tions could result in fire or malfunction.
— V
grounding.
— Speakers with 50
to 8 ohm (impedance value).
• T
tion, be sure to follow the directions belo
— Disconnect the negati
tery before installation.
— Secure the wiring with cable clamps or adhe-
siv
siv
metal parts.
— Place all cables away from mo
such as gear shift and seat rails.
— Place all cables away from hot places, such as
near the heater outlet.
— Do not pass the yellow cable through a hole
into the engine compartment to connect to a
battery
— Cover an
with insulating tape.
— Do not shorten any cables.
— Nev
this unit in order to share the power to other
equipment. Current capacity of the cable is
limited.
— Use a fuse of the rating prescribed.
— Nev
to ground.
— Nev
tiv
• Control signal is output through blue/white cable
when this unit is powered on. Connect it to an
external po
the vehicle’
(max. 300 mA, 12
equipped with a glass antenna, connect it to the
antenna booster power supply terminal.
• Nev
amp’
the power terminal of the auto antenna.
Otherwise, battery drain or malfunction may
result.
• IP-BUS connectors are color-coded. Be sure to
connect connectors of the same color
• Black cable is ground. This cable and other prod-
uct’
ucts such as power amp) must be wired separate-
ly
they are accidentally detached.
• Cord function may differ according to the
product, ev
connecting this system, be sure to check all
manuals and connect cords correctly
No AA
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
+
≠
+
+
≠
≠
33. Power
(sold separately)
39. Subwoofer
1*
3* 2*
4*
17.
ote
e
en
n
on t
e
n
o
ve
c
e,
the function of 3* and 5* ma
be
erent. In t
s case,
e sure to
connect 2* to
* and 4* to
*.
18.
color to each other.
19. Cap
Do not remove cap
if this terminal is
not in use.
20. Yellow
Back-up
accessory)
22. Red
Accessory
(or back-up)
21. Yellow
Connect to the constant
12 V supply terminal.
23. Red
Connect to terminal controlled
by ignition switch (12 V DC).
24. Orange/white
Connect to lighting switch terminal.
2
.I
connector
ote
In some vehicles, the ISO connector ma
e
v
e
nto two. In t
s case,
e sure
to connect to
ot
connectors.
31. Speaker
White: Front +
White/black: ≠
Gray: Front +
Gray/black: ≠
Green: Rear +
r
r
Green/black: ≠ or subwoofer ≠
Violet: Rear + or subwoofer +
Violet/black: ≠ or subwoofer ≠
32.
(sold separately)
28. Blue/white
Connect to system control terminal of the
power amp (max. 300 mA 12 V DC).
29. Blue/white
Connect to auto-antenna relay control
terminal (max. 300 mA 12 V DC).
The pin position of the ISO connector will
differ depends on the type of vehicle. Connect
6* and 7* when Pin 5 is an antenna control
type. In another type of vehicle, never connect
6* and 7*.
38. Rear
40.
using the optional amplifier.
41.
otes
han
e the initial settin
of this unit (refer to the O
eration
anua
). T
e su
woo
er out
ut o
t
s un
t
s monaura
.
• Ω ) , be sure to connect
with Violet and Violet/black leads of this unit. Do not connect
anything with Green and Green/black leads.
27. Yellow/black
If you use an equipment with Mute
function, wire this lead to the Audio
Mute lead on that equipment. If not,
keep the Audio Mute lead free of any
connections.
se a stereo m
n
u
ca
to connect w
t
aux
ar
e
u
ment.
25.
Connect to a clean, paint-free metal location.
1.
Connector
3.
2. Dock
4.
(sold separately)
2 m
6. This
7. Rear
8. Front
9. Antenna jack
10. Subwoofer output
11. Fuse (10 A)
12. ø )
1
.
re
remote
n
u
ar
-
re
remote contro
a
a
tor can
e connecte
so
se
arate
).
14. IP-B
n
ut (B
ue
15. IP-BUS
1
. Mu
t
-CD
a
er
(sold separately)
33. Power
(sold separately)
33. Power
(sold separately)
34.
30. Blue/white
35. Front 35. Front
36. Left
37. Right
38. Rear
39. Subwoofer
15 cm
5. Gray
Connecting the Units
ENGLISH
Connection Diagram
1. iPod with Dock Connector
2. Dock connector
3. Dock connector port
4. Interface cable (e.g., CD-I200) (sold separately)
5. Gray
6. This product
7. Rear output
8. Front output
9. Antenna jack
10. Subwoofer output
11. Fuse (10
12. Aø)
Use a stereo mini plug cable to connect with
auxiliary equipment.
13. W
Hard-wired remote control adaptor can be con-
nected (sold separately).
14. IP-BUS input (Blue)
15. IP-BUS cable
16. Multi-CD player (sold separately)
17. Note:
Depending on the kind of vehicle, the function of
3* and 5* may be different. In this case, be sure
to connect 2* to 5* and 4* to 3*.
18. Connect leads of the same color to each other
19. Cap (1*)
Do not remove cap if this terminal is not in use.
20. Y
Back-up (or accessory)
21. Y
Connect to the constant 12
22. Red (5*)
Accessory (or back-up)
23. Red (4*)
Connect to terminal controlled by ignition switch
(12 V DC).
24. Orange/white
Connect to lighting switch terminal.
25. Black (chassis ground)
Connect to a clean, paint-free metal location.
26. ISO connector
Note:
In some vehicles, the ISO connector may be
divided into tw
to both connectors.
27. Y
If you use an equipment with Mute function,
wire this lead to the
equipment. If not, keep the
of any connections.
28. Blue/white
Connect to system control terminal of the power
amp (max. 300 mA 12
29. Blue/white (7*)
Connect to auto-antenna relay control terminal
(max. 300 mA 12
30. Blue/white (6*)
The pin position of the ISO connector will differ
depends on the type of vehicle. Connect 6* and
7* when Pin 5 is an antenna control type. In
another type of vehicle, ne
31. Speaker leads
White: Front left
+
White/black: Front left ≠
Gray: Front right +
Gray/black: Front right ≠
Green: Rear left + or subwoofer +
Green/black: Rear left ≠ or subwoofer ≠
V Rear right + or subwoofer +
V Rear right ≠ or subwoofer ≠
32. Connect with RCA cables (sold separately)
33. Power amp (sold separately)
34. System remote control
35. Front Speaker
36. Left
37. Right
38. Rear Speaker
39. Subwoofer
40. Perform these connections when using the
optional amplifier
41. Notes:
• Change the initial setting of this unit (refer to
the Operation Manual). The subwoofer output
of this unit is monaural.
• When using a subwΩ), be
sure to connect with
leads of this unit. Do not connect anything with
Green and Green/black leads.
