Bedienungsanleitung Pioneer dvd v 7300 (Seite 90 von 96) (Englisch)

138248

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

Troubleshooting

If you are wondering whether you have a breakdown, please

check and find out. A slight mistake in operation can make

you think that you have a breakdown. Furthermore, factors

other than this player can also be considered. Check the tel-

evision, the AV amplifier and the speakers, etc., that you use

together with this player. When the problem is not corrected,

even after inspecting again according to the items below, con-

tact the store where you purchased the player or the nearest

PIONEER authorized service center.

Power does not come on.

➡Connect the power cord to the outlet properly (page 86 - 89).

Even when the disc table is closed, it comes

out.

➡Set the disc in the disc table properly (page 16).

➡Clean the disc (page 8).

➡Check the region no. (page 13, 91).

The screen does not appear.

➡Check the setting of the video output selector at the rear of

this player with the connected video terminal

(page 85, 86).

➡Confirm that connections are correct (page 83-88).

➡Make the television or AV amplifier setting, etc., to DVD play-

back setting.

Cannot play back.

➡Clean the disc (page 8).

➡Set the disc in the disc table properly (page 16).

➡Remove the condensation in the player (page 8).

➡SECAM format discs cannot be played back.

➡Insert the disc with the proper side up.

The contents of the settings disappear.

➡When the power has been turned off due to a power outage

and the power cord having been pulled out while the power

is turned on, the contents of the settings disappear. Make

sure to pull out the power cord after the power button of the

player or the power button of the remote control has been

pressed and the indicator has turned orange.

The screen stops and the operation buttons

are not accepted.

➡After pressing

STOP

, play back once more.

The mark appears on the screen.

➡The disc prohibits that operation (page 13).

The mark appears on the screen.

➡The player prohibits that operation (page 13).

Cannot use the remote control.

➡Operate within the usage range of the remote control.

(page 16)

➡Replace the dry cell batteries of the remote control with new

ones (page 5).

External synchronizing cannot be performed.

➡Refer to the EXTERNAL SYNC setting in the ADV. SETUP

menu.(page 48)

➡Check the notes under “NOTE” for the external synchroniz-

ing function. (page 82).

No sound comes from the speakers or the

sound is distorted

➡Confirm that the audio cable is properly connected

(pages 83-88).

➡Some discs prohibit 96 kHz digital output of Linear PCM

audio. With these kinds of discs, even if the [96 kHz PCM

Out] setting of [Audio 1] of the setup menu screen is set to

[96 kHz], it is automatically changed to 48 kHz and output.

(page 41).

➡During playback of a DVD recorded at 96 kHz in 16:9, when

[4:3 (Letter Box)] of [Video] is selected, even if the setting of

[96 kHz PCM Out] of [Audio 1] is set to [96 kHz], it is auto-

matically changed to 48 kHz and output (page 29).

➡Clean the disc (page 8).

➡If it has been set to the pause or slow playback mode, change

to the playback mode (page 21).

➡If the volume of the television or AV amplifier, etc., has been

set to “minimum”, raise the volume.

➡Confirm that the connector plug has been sufficiently in-

serted and that it has not been disconnected.

➡If the connector plug and terminal are dirty, wipe them.

The screen is extended vertically or horizon-

tally.

➡Adjust the [TV Screen] setting (page 30).

There are difference in volume between DVD

and CD.

➡This is due to the difference in the disc recording methods.

The picture is distorted or dark during DVD

playback

➡This player has the copy guard of an analog copy protect

system. Some discs have a copy prohibition signal. When

those types of discs are played back, a condition such as

lateral stripes on part of the screen appears, but this is not a

malfunction.

The playback screen is distorted when a DVD

video has been recorded on a VCR and played

back on a VCR

➡This player has the copy guard of an analog copy protect

system. Some discs have a copy prohibition signal and when

that kind of disc is played back on a VCR, and recorded and

played back on a VCR, it cannot be played back normally

due to the copy guard.

The television, etc., malfunctions

➡Some televisions with a wireless remote control function mal-

function due to the remote control of this player. Use them

separated from this player.

When setup menu screen appears, a screen set

to letter box suddenly becomes extended vertically.

➡When setup menu screen appears during playback in the

letter box or pan & scan modes, the screen size is forcibly

changed to the wide-screen mode, but this is not a malfunc-

tion. (See page 30)

This player may not operate normally due to outside influ-

ences such as static electricity. At such times it may operate

normally after the power cord has been temporarily unplugged

and plugged in again. When the problem has not been solved

by this procedure, consult the store where you purchased

the player or the nearest service station.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer dvd v 7300 Seite 90

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info