Bedienungsanleitung Pioneer FH-X721BT (Seite 6 von 88) (Englisch, Französisch, Spanisch)

574472

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

6En

Remove the insulation sheet before use.

WARNING

• Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor

immediately.

• Do not expose the battery or remote control to excessive heat such as direct sunlight or fire.

CAUTION

• There is a potential danger of explosion if the battery is incorrectly replaced. When replacing the

battery, replace it with the same type.

• Do not handle or store the battery with metallic tools or objects.

• If the battery leaks, remove the battery and wipe the remote control completely clean. Then install a

new battery.

• When disposing of used batteries, compliance with governmental regulations or environmental

institutions’ rules that apply in your country/area must be followed that pertain to any special

handling needed for disposal.

• “Perchlorate Material - special handling may apply.

See www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable to California, U.S.A.)”

Important

• Do not store the remote control in high temperatures or direct sunlight.

• Do not let the remote control fall onto the floor, where it may become jammed under the brake or

accelerator pedal.

When you turn the ignition switch to ON after installation, [SET UP :YES] appears in the

display.

1 Press the M.C. dial.

The setup menu disappears after 30 seconds of no operation. If you prefer not to set

t this time, turn the M.C. dial to select [NO], then press to confirm.

2 Turn the M.C. dial to adjust the hour, then press to confirm.

The indicator moves to the minute setting automatically.

3 Turn the M.C. dial to adjust the minute, then press to confirm.

[QUIT] appears.

4 Turn the M.C. dial to select [YES], then press to confirm.

NOTES

• You can cancel the menu setting by pressing SRC/OFF.

• This setting can be made at any time. See page 17 for more details.

1 Press the M.C. dial to display the main menu.

2 Turn the M.C. dial to select [SYSTEM], then press to confirm.

3 Turn the M.C. dial to select [DEMO OFF], then press to confirm.

4 Turn the M.C. dial to select [YES], then press to confirm.

1 Press and hold SRC/OFF until the unit turns off.

2 Press the M.C. dial to display the main menu.

3 Turn the M.C. dial to select [INITIAL], then press to confirm.

4 Turn the M.C. dial to select an option, then press to confirm.

NOTE

The options vary depending on the unit.

Appears when the iPod control function is set (page 9).

Appears when a Bluetooth connection is made (page 10).

(Only for Bluetooth-compatible models.)

Preparing the remote control

Indication Description

How to replace the battery

Insert the CR2025 (3 V) battery with the plus (+) and

minus (–) poles orientated properly.

Setting the clock (CLOCK SET)

Canceling the demonstration display (DEMO OFF)

INITIAL settings

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer FH-X721BT Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info