Bedienungsanleitung Pioneer HTP-330 (Seite 9 von 62) (Englisch)

573849

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

Connecting up

English

1 Fasten the spacers to the display unit and connect.

If the display unit is difficult to view, the spacers can be

attached to allow changing of the viewing angle. Peel off

the protective paper from the spacers and press the

spacers onto the depressions on the bottom of the display

unit.

Plug the L-shaped end of the display cable into the

connector on the rear of the display unit, then plug the

other end of the display cable into

SYSTEM CONNECTOR

jack on the receiver subwoofer.

2 Assemble the AM loop antenna.

a. Bend the stand in the direction indicated by the arrow.

b. Clip the loop onto the stand.

c. If you want to fix to a wall or other surface, perform

step b after first securing the stand with screws.

It is recommended that you determine the reception

strength before securing the stand with the screws.

3 Connect the AM and FM antennas

a. Connect one wire of the AM loop antenna to each AM

antenna terminal

For each terminal, press down on the tab to open;

insert the wire, then release to secure.

b. Push the FM antenna

plug onto the center pin of the

FM antenna socket.

4 Connect each speaker.

• The front and surround speaker cables have a color-

coded connector at one end and two bare wires at the

other end.

• Since there is only one terminal to connect the two

center speakers, you will need to use the supplied Y-

cable for the connection.

• Twist and pull off the protective shields on each wire.

• Connect the wires to the speaker. Each speaker in the

illustration can be identified by means of the color-

coded indicator provided on the rear-surface model

label. Match the color-coded wire with the color

indicator on the model label, then insert the color-

coded wire into the red (

) side and the other wire

into the black (

–

) side.

• When connecting the center speakers, connect the Y-

cable dual end to the two center speakers in the

same way.

Note

1• Keep antenna cables away from other cables, the display unit and receiver subwoofer.

• If reception with the supplied antenna is poor, see

Improving poor FM reception

and

Improving poor AM sound

on page 19 or

Connecting

external antennas

on page 23.

• Do not attach any antenna other than the provided loop antenna, or an external antenna as described on page 23.

2• Don’t let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances.

• If radio reception is poor, you may be able improve it by re-inserting each antenna wire into the opposite terminal.

• For best reception, do not untwist the AM loop antenna wires or wrap them around the loop antenna.

3 To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of the unit.

a b c

Color-coded wire

(Connect to speaker)

Color-coded connector

(Connect to rear panel)

Y-cable

To Receiver subwoofer

HTP-330.book 9 ページ２００７年３月２７日　火曜日　午後６時８分

Downloaded from www.Manualslib.com manuals search engine

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer HTP-330 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info