Bedienungsanleitung Pioneer HTP-LX70 (Seite 7 von 94) (Englisch)

571889

Zoom out

Zoom in

Vorherige Seite

1/94

Nächste Seite

Speaker Setup Guide

2 Attach the speaker bases.

Place the speaker atop a supplied speaker base, and fix

the base in place by using one of the supplied screws.

• The supplied speaker bases come in two different

shapes. You can determine the correct base for a

speaker by checking if the screw’s location lines up

correctly when the speaker is placed atop the base.

(There are specific bases for the front/center (L) and

surround speaker (R), and for the front/center (R) and

surround speaker (L), with two of each type included.)

When not using the supplied speaker bases

• Attach the non-skid pads to the base of each of

the front/center and surround speakers (as shown).

Use the adhesive side of the pads to attach them to the

base of each speaker.

Connect the speaker system

Refer to

Connecting up

to connect the speakers properly.

After connecting everything, place the speakers as

shown in the diagram above for optimal surround sound.

After placing the speakers, run the Auto MCACC setup

(page 23) to complete your surround sound setup.

Additional notes on speaker placement

• Install the main front left and right speakers at an

equal distance from the TV.

• When using the Standard surround setup, install the

surround speakers slightly above ear level for

optimum effect.

• When using the Front surround setup, separate the

left and right speakers by about 1.5 m for optimum

effect.

Precautions:

• Do not place the speaker on an unstable surface, as

doing so may cause the speaker to fall and cause

damage or bodily injury.

• All speakers supplied with this system are

magnetically shielded. However, depending on the

installation location, color distortion may occur if a

speaker is installed extremely close to the screen of a

television set. If this happens, turn the power switch

of the television set OFF, and turn it ON after 15 min

to 30 min. If the problem persists, place the speaker

system away from the television set.

• For safety, make sure that there is no exposed bare

speaker wire outside of the speaker terminals.

• Do not connect the supplied speakers with any other

amplifier. This may result in malfunction or fire.

• Do not connect any speakers other than those

supplied to this system.

• The speaker system grill cannot be removed. Do not

try to forcibly remove it since doing so may damage

the grille.

• When cleaning the cabinet, use the provided

cleaning cloth.

Do not allow alcohol, thinner, benzene, or

insecticides to come into contact with the surface,

since finish discoloration may occur.

Also, when using chemically impregnated cleaning

cloths, follow their precautions carefully.

Speaker

Screw

Speaker base

Front/center and surround speakers

Non-skid pads x 16

HTP-LX70_En.book 7 ページ２００７年９月２８日　金曜日　午前１０時５１分

Downloaded from www.Manualslib.com manuals search engine

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer HTP-LX70 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info