Bedienungsanleitung Pioneer HTZ180DVD (Seite 15 von 106) (Englisch, Spanisch)

573909

Zoom out

Zoom in

Vorherige Seite

1/106

Nächste Seite

Getting started 04

English

FrançaisDeutsch

Nederlands

Italiano Español

Chapter 4

Getting started

Setting Speaker Layout

Select the speaker layout for the speaker

setting you arranged to your listening area

environment.

First time you switch on the system, the

following speaker layout setting appears. If you

switch off the system without finishing this

setting, the same appears again next time you

switch on the system.

1 Press

 STANDBY/ON

and confirm

WELCOME is shown on the display.

2 SELECT SPEAKER LAYOUT will run on

the display for about 10 seconds.

3Use / to select appropriate speaker

layout.

There are two speaker layout modes – 5 spot

speaker layout and 3 spot speaker layout.

See Setup Guide for more details about

speaker layout and mode description.

• 5 SPOT – Optimal for 5.1 channel home

theater sound by placing the two surround

speakers in the rear of the listening

position.

• 3 SPOT – This is the classic layout for the

Front Surround mode. The two surround

speakers are placed in front of the listening

position.

4 Press ENTER to confirm.

Setting the channel levels

Set the relative channel levels from your main

listening position.

1Press

SHIFT+SETUP

2Use / to select SOUNDSET, then

press ENTER.

3Use / to select CH LEVEL, then press

ENTER.

4Use / to select TESTTONE, then

press ENTER.

The test tone is output in the following order

(from the speakers active in the current

listening mode):

• L – Front left speaker

• C – Center speaker

• R – Front right speaker

• SR – Surround right speaker

• SL – Surround left speaker

• SW – Subwoofer

5 Use the VOLUME +/– to adjust the

volume to an appropriate level.

6Use / to adjust the channel levels in

turn.

You should hear the test tone at the same

volume from each speaker when seated in the

main listening position. The channel level

range is ±10 dB.

7 When you’re done, press ENTER to exit

test tone setup.

Note

1 To change the setting, press SHIFT+SETUP, use / to select SYS SET, then use / to select LAYOUT to start setting

procedure.

2 • This is only available when DVD/CD is selected and playback is stopped. Also make sure headphones are unplugged.

• To adjust the overall balance while listening to any sound source you want, press SHIFT+SETUP, use / to select

SOUNDSET, then press ENTER. Use / to select CH LEVEL, then press ENTER. Use / to switch between channels, and

/ to adjust the channel levels. Press ENTER when you’re finished.

3 Since the subwoofer produces ultra-low frequencies its sound may seem quieter than it actually is.

4 When the volume is set to 51 or more, TESTTONE cannot be selected and the channel level setting range is restricted. In

addition, if the channel level range of any speaker is set to the + side, the maximum volume is also restricted.

HTZ180DVD_en_RXJ.book 15 ページ２００９年３月１７日　火曜日　午後６時５３分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer HTZ180DVD Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer HTZ180DVD

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info