Bedienungsanleitung Pioneer MVH-A210BT (Seite 3 von 48) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

699593

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

3En

English

control terminal, the auto-aerial relay

control terminal, or the aerial booster

power control terminal (max. 300 mA 12

V DC). The control signal is output

through the blue/white lead, even if the

audio source is switched off.

Microphone 3 m

This product

Aerial jack

Wired remote input

Connect to steering wheel control

int

erface of your vehicle. For more

details, consult your dealer.

Power supply

Fuse (10 A)

Front output

Rear output

Subwoofer output

To power supply

Depending on the kind of vehicle, the

function of 2* and 4* may be different.

n this case, be sure to connect 1* to 4*

and 3* to 2*.

Yellow (2*)

Back-up (or accessory)

Yellow (1*)

Connect to the constant 12 V supply

rminal.

Red (4*)

Accessory (or back-up)

Rear panel

Power cord

Red (3*)

Connect to terminal controlled by

ignition switch (12 V DC).

Connect leads of the same colour to

each other.

Orange/white

To lighting switch terminal.

Black (earth)

To vehicle (metal) body.

Blue/white (5*)

The pin position of the ISO connector

ill differ depending on the type of

vehicle. Connect 5* and 6* when Pin 5 is

an aerial control type. In another type of

vehicle, never connect 5* and 6*.

Blue/white (6*)

Connect to auto-aerial relay control

erminal (max. 300 mA 12 V DC).

Blue/white

Connect to system control terminal of

e power amp (max. 300 mA 12 V DC).

Violet/white

Of the two lead wires connected to the

back

lamp, connect the one in which

the voltage changes when the gear shift

is in the REVERSE (R) position. This

connection enables the unit to sense

whether the car is moving forwards or

backwards.

Light green

Used to detect the ON/OFF status of the

han

dbrake. This lead must be

connected to the power supply side of

the handbrake switch.

Connection method

Clamp the lead (1) then clamp firmly

ith needle-nosed pliers (2).

Power supply side

Handbrake switch

Earth side

Speaker leads

White: Front left + or high range left +

White/black: Front left – or high range

ft –

Grey: Front right + or high range right +

Grey/black: Front right – or high range

ght –

Green: Rear left + or middle range left +

Green/black: Rear left – or middle range

ft –

Violet: Rear right + or middle range

ght +

Violet/black: Rear right – or middle

nge right –

ISO connector

In some vehicles, the ISO connector

y be divided into two. In this case, be

sure to connect to both connectors.

NOTES

• The position of the handbrake switch

depends on the vehicle model. For

details, consult the vehicle Owner’s

Manual or dealer.

• When a subwoofer is connected to this

product instead of a rear speaker, change

the rear output setting in the initial

setting. The subwoofer output of this

product is monaural.

• W

hen using a subwoofer of 2 Ω, be sure

to connect the subwoofer to the violet

and violet/black leads of this unit. Do not

connect anything to the green and

green/black leads.

Important

The speaker leads are not used when this

connection is in use.

Power amp (sold

separately)

Without internal amp

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer MVH-A210BT Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer MVH-A210BT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info