Bedienungsanleitung Pioneer RCS-606H-S (Seite 17 von 152) (Englisch)

573927

Zoom out

Zoom in

Vorherige Seite

1/152

Nächste Seite

Remote control

English

SOUND (page 27)

Press to access the sound menu, from which you can

adjust bass and treble, etc.

CLEAR

Press to clear an entry and start again.

23 MENU (page 87)

Press to display the disc menu if a DVD-Video, finalized

DVD-R/-RW or finalized DVD+R/+RW disc is loaded.

When in the GUIDE Plus+™ system, use to jump directly

to the Menu bar.

24 VIDEO IN (page 82)

Press to change the DVD recorder input for recording

and playback.

25 TV/DVD

Press to switch between ‘TV mode’, in which you get the

picture and sound from the TV’s tuner, and ‘DVD mode’,

in which you get picture and sound from the system’s

tuner (or an external input).

26 JUKEBOX (page 113)

Press to display the Jukebox screen of the DVD recorder,

from where you can copy music to the HDD for playback.

27 TV CONTROL (page 136)

After setting up, use these controls to control your TV.

28 DISPLAY (page 95)

Displays/changes the on-screen information

displays.

RDS DISP

Changes RDS displays (page 30).

MAIN

SUB

Change from MAIN to SUB to access the green

functions/commands on the remote.

Using the remote control

Please keep in mind the following when using the remote

control:

• Make sure that there are no obstacles between the

remote and the remote sensor on the unit.

• Remote operation may become unreliable if strong

sunlight or fluorescent light is shining on the unit’s

remote sensor.

• Remote controllers for different devices can interfere

with each other. Avoid using remotes for other

equipment located close to this unit.

• Replace the batteries when you notice a fall off in the

operating range of the remote.

• When the batteries run down or you change the

batteries, the remote control mode is reset to

Recorder 1. See Remote Control Mode on page 134.

• Use within the operating range in front of the remote

control sensor on the display unit, as shown.

Putting the batteries in the remote

control

1 Open the battery compartment cover on the

back of the remote control.

2 Insert two AA/R6 batteries into the battery

compartment following the indications (,) inside

the compartment.

3 Close the cover.

Caution

Incorrect use of batteries can result in hazards such

as leakage and bursting. Please observe the

following:

• Don’t mix new and old batteries together.

• Don’t use different kinds of battery together—

although they may look similar, different batteries

may have different voltages.

• Make sure that the plus and minus ends of each

battery match the indications in the battery

compartment.

• Remove batteries from equipment that isn’t going to

be used for a month or more.

• When disposing of used batteries, please comply

with governmental regulations or environmental

public instruction’s rules that apply in your country or

area.

WARNING

• Do not use or store batteries in direct sunlight or

other excessively hot place, such as inside a car or

near a heater. This can cause batteries to leak,

overheat, explode or catch fire. It can also reduce the

life or performance of batteries.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer RCS-606H-S Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer RCS-606H-S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info