Bedienungsanleitung Pioneer S-DV232T (Seite 36 von 85) (Englisch)

574061

Zoom out

Zoom in

Vorherige Seite

1/85

Nächste Seite

Additional information08

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is

something wrong with this component, check the points below. Sometimes the trouble may lie in

another component. Investigate the other components and electrical appliances being used. If the

trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer

authorized service center or your dealer to carry out repair work.

• If the system does not operate normally due to external effects such as static electricity

disconnect the plug from the outlet and insert again to return to normal operating conditions.

General

Problem

Remedy

The power does not

turn on, or switches off

suddenly (an error

message may be

displayed at startup).

• Leave the unit plugged in, wait for one minute, then switch back on.

• Make sure there are no loose strands of wire touching the unit. This could

cause the system to shut off automatically.

• Check that the speakers are connected correctly.

• Make sure the voltage of the mains power source is correct for the model.

• Try reducing the volume level.

• If the problem persists, take it to your nearest Pioneer authorized service

center or your dealer for servicing.

No sound is output

when a function is

selected.

• If you’re using the line input, make sure the component is connected

correctly (see

Connecting auxiliary components

on page 25).

• Press

MUTE

on the remote control to turn muting off.

No image is output

when playing discs.

• Make sure the TV is connected correctly (refer to the Setup Guide).

• Reset the video output to interlace (see

Video Output settings

on page 20).

No sound from

surround or center

speakers.

• Refer to

Setting the channel levels

on page 6 to check the speaker levels.

• When

TUNER

LINE

is selected, you can only hear the source in stereo.

Switch the input source to

DVD/CD

for multichannel sound.

• Check that the Recording mode hasn’t been switched on (see

Recording

mode

on page 25).

• Check that you haven’t selected the

STEREO

mode (see

Listening in

surround sound

on page 11).

• Connect the speakers properly (refer to the Setup Guide).

Can’t operate the

remote control.

• Replace the batteries (refer to the Setup Guide).

• Operate within 7 m, 30° of the remote sensor (refer to the Setup Guide).

• Remove any obstacles or operate from another position.

• Avoid exposing the remote sensor on the front panel to direct light.

SND. DEMO

shows in

the display and the unit

can’t be controlled.

• Press and hold



(stop) on the front panel for about ﬁve seconds. The disc

tray ejects automatically to indicate the Sound Demo mode is disabled.

XV-DV131_232T.book 36 ページ２００５年５月１１日　水曜日　午後１時４６分

Downloaded from www.Manualslib.com manuals search engine

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer S-DV232T Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info