Bedienungsanleitung Pioneer SC-LX79 (Seite 139 von 151) (Englisch)

611788

139

Zoom out

Zoom in

Vorherige Seite

1/151

Nächste Seite

139

Additional information

Position of center speaker and monitor

Since mostly dialogs are output from the center speaker, keeping the center speaker as close as possible to the

screen makes the overall sound more natural. For TVs using Braun tubes, however, when installing the center

speaker on the floor, adjust its angle of elevation to point it towards the listening position.

Installation on floor

(Diagram as seen

from the side)

Monitor

! If the center speaker is not of the shielded type, install it away from the TV.

! When installing the center speaker on top of the monitor, place it facing slightly downwards towards the listen-

ing position.

About messages displayed when using network functions

Refer to the following information when you come up with a status message while operating the Network

functions.

Status messages Descriptions

Connection Down

The selected category or Internet radio station cannot be accessed.

File Format Error

Cannot be played back for some reasons.

Track Not Found

The selected song has not been found anywhere on the network.

Server Error

The selected server cannot be accessed.

Server Disconnected

The server has been disconnected.

Empty

There are no files stored in the selected folder.

License Error

The license for the contents to be played back is invalid.

Item Already Exists

This is displayed when the file you have attempted to register in the Favorites folder has

already been registered.

Favorite List Full

This is displayed when you have attempted to register a file in the Favorites folder but the

Favorites folder is already full.

Important information regarding the HDMI connection

There are cases where you may not be able to route HDMI signals through this receiver (this depends on

the HDMI-equipped component you are connecting-check with the manufacturer for HDMI compatibility

information).

If you aren’t receiving HDMI signals properly through this receiver (from your component), please try one of the

following configurations when connecting up.

Configuration A

Use component video cables to connect the video output of your HDMI-equipped component to the receiver’s

component video input. The receiver can then convert the analog component video signal to a digital HDMI sig-

nal for transmission to the display. For this configuration, use the most convenient connection (digital is recom-

mended) for sending audio to the receiver. See the operating instructions for more on audio connections.

Note

The picture quality will change slightly during conversion.

Configuration B

Connect your HDMI-equipped component directly to the display using an HDMI cable. Then use the most conve-

nient connection (digital is recommended) for sending audio to the receiver. See the operating instructions for

more on audio connections. Set the display volume to minimum when using this configuration.

Notes

! If your display only has one HDMI terminal, you can only receive HDMI video from the connected component.

! Depending on the component, audio output may be limited to the number of channels available from the

connected display unit (for example audio output is reduced to 2 channels for a monitor with stereo audio

limitations).

! If you want to switch the input function, you’ll have to switch functions on both the receiver and your display

unit.

! Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the

display every time you switch input functions.

Cleaning the unit

! Use a polishing cloth or dry cloth to wipe off dust and dirt.

! When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with

water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers.

! Never use thinners, benzene, insecticide sprays or other chemicals on or near this unit, since these will cor-

rode the surface.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer SC-LX79 Seite 139

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer SC-LX79

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info