Pairing /
Calibration
Pairing with the Cyclocomputer
This section describes how to pair the installed SGX-PM900 pedaling
monitor sensors on your bicycle to the SGX-CA900 Cyclocomputer.
This pairing procedure may be different if you are using a cyclocomputer other ●
than the Pioneer SGX-CA900. Please refer to your cyclocomputer’s owner
manual for sensor pairing.
1.
Check the sensor modes.
Check that the right transmitter and the
left transmitter are in "Pedaling mode."
See page 8 to switch the modes.•
2.
Tap the [Sensors] icon in the
home screen of the SGX-CA900.
The sensor list screen opens.
3.
Rotate the bicycle's crank
set one rotation to start the
transmitter.
Pair with the Cyclocomputer within •
5 minutes after the transmitters are
activated.
4.
Tap [Connect New] in the
sensor list screen of the
SGX-CA900.
The sensor connection menu opens.
5.
Tap [Device Type] and then
[Pedaling Monitor R].
For the left transmitter, tap [Pedaling •
Monitor L].
If multiple sensors are activated, •
bring the main unit closer to the
sensor, or specify the device number
to pair the sensor you want to pair.
Refer to the User's Guide of the
Cyclocomputer SGX-CA900
regarding how to specify a device
number to pair a sensor.
6.
Tap [Search].
The search for the sensor starts.
A [Searching. Please wait.] message
appears.
