Bedienungsanleitung Pioneer VREC-DH200 (Seite 7 von 34) (Englisch)

811511

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

− 7 −

English

• Make sure that the cables and wires will not interfere with or become caught in any of the vehicle’s

moving parts, especially the steering wheel, gearstick, handbrake, sliding seat tracks, doors, or any

of the vehicle’s controls.

• Do not route wires where they will be exposed to high temperatures. If the insulation heats up, wires

may become damaged, resulting in a short circuit or malfunction and permanent damage to the

product.

• Do not shorten any cables. If you do, the protection circuit (fuse holder, fuse resistor or filter, etc.)

may fail to work properly.

• Never feed power to other electronic products by cutting the insulation of the power supply cable of

this product and tapping into the cable. The current capacity of the cable will be exceeded, causing

overheating.

To prevent damage

WARNING

• When replacing the fuse, be sure to only use a fuse of the rating prescribed on this product.

Precautions before installation

CAUTION

Never install this product in places where, or in a manner that:

• Could injure the driver or passengers if the vehicle stops suddenly.

• May interfere with the driver’s operation of the vehicle, such as on the floor in front of the driver’s

seat, or close to the steering wheel or gearstick.

• To ensure proper installation, be sure to use the supplied parts in the manner specified. If any parts

are not supplied with this product, use compatible parts in the manner specified after you have the

parts’ compatibility checked by your dealer. If parts other than supplied or compatible ones are used,

they may damage internal parts of this product or they may work loose and the product may become

detached.

• Do not install this product where it may

(i) obstruct the driver’s vision,

(ii) impair the performance of any of the vehicle’s operating systems or safety features, including

airbags, hazard lamp buttons or

(

iii) impair the driver’s ability to safely operate the vehicle.

• Never install this product in front of or next to the place in the dashboard, door, or pillar from

which one of your vehicle’s airbags would deploy. Please refer to your vehicle’s owner’s manual for

reference to the deployment area of the frontal airbags.

• Consult with your nearest dealer if installation requires drilling holes or other modifications of the

vehicle.

• Before making a final installation of this product, temporarily connect the wiring to confirm that the

connections are correct and the system works properly.

• Do not install this product in places subject to high temperatures or humidity, such as:

— Places close to a heater, vent or air conditioner.

— Places that may be exposed to rain, such as close to the door or on the vehicle’s floor.

Precautions for cigarette lighter plug

WARNING

• When using a power supply in the vehicle, use the dedicated cigarette lighter plug.

Using a plug other than the specified plug may result in fire, electric shock, or product failure.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer VREC-DH200 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer VREC-DH200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info