Bedienungsanleitung Pioneer VSX-1120-K (Seite 17 von 108) (Englisch)

574086

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

Connecting your equipment

[E] 5.1 channel surround system & ZONE 2

connection (Multi Zone)

• Speaker System setting: ZONE 2

With these connections you can simultaneously enjoy

5.1-channel surround sound in the main zone with stereo

playback on another component in ZONE 2. (The

selection of input devices is limited.)

Important

•The Speaker System setting must be made if you

use any of the connections shown above other than

[A] (see Speaker system setting on page 79).

• Sound does not come through simultaneously from

the front height, front wide, speaker B and surround

back speakers. Output speakers are different

depending on the input signal or listening mode.

Other speaker connections

•Your favorite speaker connections can be selected

even if you have fewer than 5.1 speakers (except front

left/right speakers).

• When not connecting a subwoofer, connect speakers

with low frequency reproduction capabilities to the

front channel. (The subwoofer’s low frequency

component is played from the front speakers, so the

speakers could be damaged.)

•

After connecting, be sure to conduct the Auto

MCACC (speaker environment setting) procedure.

See Automatically conducting optimum sound tuning

(Auto MCACC) on page 35.

Placing the speakers

Refer to the chart below for placement of the speakers

you intend to connect.

•Place the surround speakers at 120º from the center.

If you, (1) use the surround back speaker, and, (2)

don’t use the front height speakers / front wide

speakers, we recommend placing the surround

speaker right beside you.

• If you intend to connect only one surround back

speaker, place it directly behind you.

• Place the left and right front height speakers at least

one meter (3.3 ft.) directly above the left and right

front speakers.

THX speaker system setup

If you are using a THX certified subwoofer, use the THX

INPUT jack on the subwoofer (if your subwoofer has one)

or switch the filter position to THX on your subwoofer.

See also THX Audio Setting on page 81 to make the

settings that will give you the best sound experience

when using the Home THX modes (page 49).

Some tips for improving sound quality

Where you put your speakers in the room has a big effect

on the quality of the sound. The following guidelines

should help you to get the best sound from your system.

•The subwoofer can be placed on the floor. Ideally, the

other speakers should be at about ear-level when

you’re listening to them. Putting the speakers on the

floor (except the subwoofer), or mounting them very

high on a wall is not recommended.

•For the best stereo effect, place the front speakers 2

m to 3 m (6 ft. to 9 ft.) apart, at equal distance from

the TV.

•If you’re going to place speakers around your CRT TV,

use shielded speakers or place the spea

rs at a

sufficient distance from your CRT TV.

•If you’re using a center speaker, place the front

speakers at a wider angle. If not, place them at a

narrower angle.

Main zone

Sub zone

ZONE 2

FHL

FWL

SBL

SBR

FWR

FHR

30 30

120 120

VSX-1120_UXJCB.book 17 ページ２０１０年３月１０日　水曜日　午後２時２分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer VSX-1120-K Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info