574064
14
Zoom out
Zoom in
Vorherige Seite
1/136
Nächste Seite
Controls and displays02
14
En
7
///
,
ENTER
Use the arrow buttons when setting up your
surround sound system (page 90) and the
Audio or Video options (page 72 or 75).
8 Receiver controls
Press first to access:
PHASE CTRL Switch on/off Phase Control
(page 66).
STATUS – Check selected receiver settings
(page 79).
PQLS – Select the PQLS setting (page 70).
S.RETRIEVER – Press to restore CD quality
sound to compressed audio sources
(page 73).
MIDNIGHT – Switches to Midnight or
Loudness listening (page 72).
SIGNAL SEL – Select an input signal
(page 65).
MCACC – Switch between MCACC presets
(page 65).
SLEEP – Use to put the receiver in sleep
mode and select the amount of time before
sleep (page 79).
CH LEVEL – Press repeatedly to select a
channel, then use / to adjust the level
(page 107).
A.ATT – Attenuates (lowers) the level of an
analog input signal to prevent distortion
(page 79).
DIMMER – Dims or brightens the display
(page 79).
9 LISTENING MODE controls
AUTO/ALC/DIRECT
Switches between
Auto Surround
(page 61)
, Auto Level
Control mode and Stream Direct mode
(page 64).
STEREO – Switches between stereo
playback and Front Stage Surround
Advance modes (page 64).
STANDARD – Press for Standard decoding
and to switch between the various 2 Pro
Logic IIx and Neo:6 options (page 61).
ADV SURR – Switch between the various
surround modes (page 63).
10 Remote control LED
Lights when a command is sent from the
remote control (page 81).
11
TV CTRL
Set the preset code of your TV’s manufacturer
when controlling TV (page 82).
12
Switches the remote to control the receiver
(used to select the white commands (SIGNAL
SEL, etc.)).
Switch to perform operations in the main zone.
Also use to set up surround sound.
13
MASTER VOLUME +/–
Set the listening volume.
14
MUTE
Mutes the sound or restores the sound if it has
been muted (adjusting the volume also
restores the sound).
Operating range of remote control
unit
The remote control may not work properly if:
There are obstacles between the remote
control and the receiver’s remote sensor.
Direct sunlight or fluorescent light is
shining onto the remote sensor.
The receiver is located near a device that is
emitting infrared rays.
The receiver is operated simultaneously
with another infrared remote control unit.
RECEIVER
RECEIVER
7 m (23 ft.)
30°
30°
VSX-31_30_UC.book 14 ページ 2010年8月25日 水曜日 午前9時28分
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Pioneer VSX-30 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info