Bedienungsanleitung Pioneer VSX-C100 (Seite 54 von 60) (Englisch)

455260

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Additional Information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with

this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other

components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks

listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.

Cause

• The power plug is disconnected.

• The protection circuit may have been

activated.

• Speaker wire may be touching the rear

panel.

• Static electricity caused by dry air.

• The receiver has a serious problem.

• The receiver has gotten too hot.

• The thermistor (temperature sensor) is

out of order.

• Improper connections.

• Sound is muted.

• The volume is turned down.

• Incorrect frequency.

• The antenna is not connected.

FM broadcasts

• The FM antenna is not fully extended

or is poorly positioned.

• Weak radio signals.

AM broadcasts

• The AM antenna is poorly positioned.

• Weak radio signals.

• Interference caused by other equipment

(fluorescent lamp, motor, etc.).

• The radio signal is too weak .

Symptom

The power does not

turn on.

AMP ERR blinks in

the display and the

unit turns off.

HEAT UP blinks in the

display.

OVERHEAT blinks in

the display and no

sound is output.

THDCT NG blinks in

the display and no

sound is output.

The unit does not

respond when the

buttons are pressed.

No sound is output

when the AM/FM is

selected.

Considerable noise in

radio broadcasts.

Broadcast stations

cannot be selected

automatically.

Remedy

• Connect the power plug to the wall outlet.

• Disconnect the power plug from the outlet,

and insert again.

• Make sure there are no loose strands of

speaker wire touching the rear panel. This

could cause the receiver to shut off auto-

matically.

• Disconnect the power plug from the outlet,

and insert again.

• Unplug the receiver from the wall and call a

Pioneer-accredited repair center.

• Allow the receiver to cool down with good

ventilation. If problem persists turn off re-

ceiver, unplug from wall and allow it to cool

down.

• Turn the receiver off and allow it to cool

down with good ventilation. If problem

persists turn the volume down.

• Turn the receiver off, unplug from wall and

call a Pioneer-accredited repair center.

• Make sure the component is connected cor-

rectly (refer to pages 12–15).

• Press MUTE on the remote control.

• Adjust the MASTER VOLUME.

• Tune in the correct frequency.

• Connect the antenna (refer to page 18).

• Fully extend the FM wire antenna, position

for best reception, and secure to a wall.

• Connect an outdoor FM antenna (refer to

page 18).

• Adjust the direction and position for best

reception.

• Connect an additional internal or external

AM antenna (refer to page 18).

• Turn off the equipment causing the noise or

move it away from the receiver.

• Place the antenna farther away from the

equipment causing the noise.

• Connect an outdoor antenna (refer to page

18).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer VSX-C100 Seite 54

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer VSX-C100

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info