Bedienungsanleitung Pioneer VSX-D309 (Seite 42 von 48) (Englisch)

574207

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Additional Information

Symptom

Broadcast stations

cannot be selected

automatically.

No sound from

surround or center

speakers.

Sound is produced

from other

components, but not

from LD or DVD

player.

No sound is output or

a noise is output when

software with DTS is

played back.

When a search is

performed by a DTS

compatible CD player

during playback, noise

is output.

Cannot be remote

controlled.

The display is dark or

off.

Cause

• Weak radio signal.

• Speaker settings are incorrect.

• The rear and/or center levels are

turned down.

• The surround and/or center speakers

are disconnected.

• SIGNAL SELECT is set incorrectly.

• The digital inputs are assigned

incorrectly, or not at all.

• SIGNAL SELECT is set to “ANALOG”.

• A DVD player not compatible with

DTS is used, or the setting of DVD

player is incorrect.

• The digital output level is adjusted on

a CD player or other component

equipped with digital output level

adjustment capability. (The DTS

signal has been altered by the player,

and cannot be read.)

• The search function performed by the

player slightly alters the digital

information, making it unreadable.

• The remote control batteries have

worn out.

• Too far away or bad angle of

operation.

• There is an obstacle between the

receiver and the remote control.

• Strong light such as fluorescent light

is shining onto the unit's remote

control signal light-receiving

window.

• The FL DIMMER button is pushed.

Remedy

• Connect an outdoor antenna (refer to

page 8).

• Refer to “SPEAKER setting mode” on

page 15 to check the speaker

settings.

• Refer to “Setting the volume level of

each channel” on page 19 to check

the speaker levels.

• Connect the speakers (refer to page

12).

•

Set SIGNAL SELECT to “DIGITAL” or

“ANALOG” according to the type of

connections made. (refer to page 28).

• Set the digital input settings correctly

(refer to page 18-19).

• Make digital connections (refer to

page 11) and set SIGNAL SELECT to

“DIGITAL” (refer to page 28).

• Refer to the instruction manual

supplied with the DVD player.

• Set the digital volume level of the

player to full, or to the neutral

position.

• This is not a malfunction, but be sure

to turn the volume down to prevent

the output of loud noise from your

speakers.

• Replace the batteries (refer to page 7).

• Operate within 23 feet ( 7 m), 30° of

the remote sensor on the front panel

(refer to page 7).

• Remove the obstacle or operate from

another position.

• Avoid exposing the remote sensor on

the front panel to direct light.

• Press FL DIMMER on the remote

control repeatedly to return to the

default.

If the unit does not operate normally due to external effects such as static electricity

Disconnect the power plug from the outlet and insert again to return to normal operating conditions.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer VSX-D309 Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info