Bedienungsanleitung Pioneer XC-L77 (Seite 10 von 48) (Englisch)

572154

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

2 Installing and Connecting Up

Placing the satellite speakers

The speakers come with stands that can be used if you plan to put the speakers on a

shelf or table. It’s possible to attach the stands so that the speakers stand upright (as

shown in the illustration on the facing page, for example), or on their side—as

shown in the diagram left. Attach a stand to each speaker using the supplied screws

(two per stand). Next, fix two of the supplied non-slip pads to the underside of each

speaker (it makes no difference which way up the speakers are when they are placed

horizontally).

As an alternative to placing your speakers on a shelf or table, you may want to wall-

mount them. The rear panel of each speaker has two screw holes for this purpose—

use the single top one for vertical mounting, or both for horizontal mounting. Hang

the speakers from screws in the wall as you would a picture. Screws and other

mounting fixtures are not supplied. If you decide to wall-mount the speakers, make

sure that the wall is capable of supporting the weight of the speakers.

Choosing a listening position

Ideally, the satellite speakers should be at about ear-level when you’re listening to

them. Putting the speakers on the floor, or mounting them very high on a wall is not

recommended. For the best stereo effect, place the speakers 2–3 meters apart, and

choose as your listening position a point within the shaded triangle below.

Placing the subwoofer

Placement of the subwoofer is not as critical as the satellite speakers because bass

sounds are much less directional than middle and treble sounds. However, bear the

following points in mind when choosing a suitable location:

❖ The subwoofer’s speakers are at the rear of the unit. Place the subwoofer at

least 5cm away from a wall for best results.

❖ As with other audio components, don’t place the subwoofer near heaters,

radiators or other appliances that generate heat.

❖ Although you have some freedom in placement, experiment with different

subwoofer locations—some will sound better than others from your usual

listening position.

Note: Before placing the subwoofer, attach the four supplied non-slip pads to the

underside of the unit. Avoid touching the actual speaker cones of the subwoofer unit

when installing or moving it.

Note

Screws for wall mounting are

not supplied. Use screws

suitable for the type of ma-

terial and strength of the wall

or surface.

Mount the speakers only on

a vertical wall or surface.

Pioneer bears no responsi-

bility for accidents resulting

from faulty assembly or in-

stallation, insufficient

mounting strength of walls

or other building fixtures,

misuse, or natural disasters.

Stand attached for

horizontal placement

Screw holes for

wall mounting

Listening

area

2–3 meters

Non-slip pads

For S-L8 speakers: for correct

balance, make sure that the

speaker stands are fixed to the

upper two screw holes when plac-

ing horizontally.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer XC-L77 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info