Bedienungsanleitung Plantronics CS510A (Seite 19 von 21) (Englisch)

520220

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

Place an Outgoing Call

1 Wearing your headset, press the headset call control button.

2 Remove the handset from the cradle. You will hear a dial tone.

NOTE This step will be automatic if you install a lifter or EHS cable accessory. For a complete list of

accessories, visit plantronics.com/accessories.

3 Dial the number using your desk phone.

4 To end the call, press the headset call control button and hang up the handset.

Answer an Incoming Call

1 Wearing your headset, press the headset call control button.

2 Remove the handset from the cradle speak to your caller.

NOTE This step will be automatic if you install a lifter or EHS cable accessory. For a complete list of

accessories, visit plantronics.com/accessories.

3 To end the call, press the headset call control button and hang up the handset.

Conference Up to Three Additional Headsets

You can conference up to three additional headsets to a call in progress.

Join a Conference Call

While in an active link between the primary headset and the base (on a call), place the guest

headset into the primary user’s charge cradle (this connects the headset to the base). The base

subscription LED will begin ﬂashing. After a few moments, the primary user will hear a triple

tone in their headset indicating the guest headset wishes to join the call. Within ten seconds of

hearing the triple tone, press the primary headset’s call button to accept the guest headset. If

the process fails or times out because the button was not pressed within ten seconds the guest

subscription is terminated and the guest will hear an error tone in their headset.

To connect a guest headset that is of different variety than the primary headset press the base

subscription button while the base has an active link. Next, press the guest headset volume

up button until the indicator light turns on. The base subscription LED will begin ﬂashing and

the primary user will hear a triple tone in their headset indicating the guest headset wishes

to join the call. Within ten seconds of hearing the triple tone, press the primary headset’s call

button to accept the guest headset. If the process fails or times out because the button was

not pressed within ten seconds the guest subscription is terminated and the guest will hear an

error tone in their headset.

NOTE Headsets in a conference maintain independent mute controls. The base only indicates the

primary user’s mute state.

Exit a Conference Call

Guests headsets can remain as guests through multiple calls. To remove a guest headset, press

the guest headset’s call control button or dock the primary user’s headset in the charge cradle.

A single tone in the master headset will be heard as each guest leaves the call.

NOTE The user of the primary headset in a multiple headset conference scenario may hear

additional tones (triple tones) in their headset and see the subscription LED on the base ﬂash as

guest headsets join the call. These additional tones and ﬂashing LED indicate that the guest headset

has a different version of ﬁrmware than the primary headset, but can still be used for conferencing.

Daily Use

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Plantronics CS510A Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Plantronics CS510A

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info