__________________________________________28_________________________________________
3.2 Card Width Adjustment
For smooth and fast Dealer4 operation, it is important to have the Card Feeder set to the correct width.
Feeder width should always be set relative to the card width. A width that is too small can lead to
problems with card feeding and even can make it impossible to fit cards into the Feeder. A width that is
too large makes the feeding process more difficult (a card can rotate slightly and block itself) and the
card symbols can go outside the viewing area of the camera.
An incorrect Feeder width can result in a number of different errors but most commonly Card Feeding
Error (Error 55 or 56) and Card Recognize Error (Error 25 to 53).
Card Feeder width should be set to be 1-2mm wider then the width of the card. It is adjusted by rotating
the Card Width Adjustment Knob located on the front panel of the machine:
To adjust the card width, put one card into the Feeder and by turning adjustment knob set the adjust
plate to touch the card on side:
