Bedienungsanleitung Polar PFL 1009 (Seite 2 von 2) (Englisch)

632187

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

5019 801 01003

Programme

Temperature

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes)

Cotton 95 5.0 49* 1.90 2:00

Cotton ** 60 5.0 44 0.85 2:20

Cotton 40 5.0 44 0.60 2:00

Synthetics 60 2.5 50* 0.70 1:30

Synthetics 40 2.5 45 0.55 1:15

Delicates 30 1.5 50 0.50 0:45

Quick wash 30 3.0 40 0.40 0:30

Wool

40 1.0 55 0.60 0:45

Handwash 40 1.0 45 0.60 0:40

Lingerie 30 1.0 45 0.50 0:36

Add detergents as indicated on the front page and

as described in your Instructions for Use.

Close the door and turn the programme

selector to the desired programme and

temperature. The indication lamp next to the

“Start/Pause”

button flashes.

CONSUMPTION DATA

Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data

in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load

and the type of wash.

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the

water out.

** Reference Programme for Energy Label.

ADD DETERGENTS, CLOSE THE DOOR AND

SELECT THE PROGRAMME

“DOOR OPEN” INDICATION

Before starting and after end of a programme, the

lamp lights to show the the door can be opened.

As long as a wash programme is running, the door

remains locked and must on no account be forced

open. In case you have an urgent need to open

it during a running programme, refer to “Cancel

(Reset) a running programme before the end”.

RED INDICATIONS

“Service”

Lighting up of the “Service” indication can be

caused by a fault in an electrical component.

Refer to the “Troubleshooting Guide” in your

“Instructions for Use”; if the fault persists, contact

our After Sales Service.

“Water tap closed”

The appliance has no or insufficient water supply.

Open the water tap: if the indications still lights

up, refer to the “Troubleshooting Guide” in the

Instructions for Use.

“Clean pump”

Waste

water is not pumped out. Check whether

the drain hose is kinked or the filter must be

cleaned: in the latter case refer to the Instructions

for Use (“Removing the Filter”).

PROGRAMME START

Open the tap and press the “Start/Pause”

button. The indication lamp next to the “Start/

Pause”

button lights up. The programme

sequence indicator shows the current programme

phase, running from left to right through Wash,

Rinse, Spin/Drain.

When the programme phrase is finised, the

corresponding indication goes out.

PROGRAMME END

• All the lights of the programme sequence

indicator are off, and the “Door open”

indication lights up.

1. Turn the programme selector to the “Off/O”

position.

2. Close the water tap.

3. Open the door and unload the machine.

4. Leave the door ajar to allow the drum to dry.

CHANGE PROGRAMME AND/OR OPTIONS

AFTER PROGRAMME START

1. Press the “Start/Pause” button to pause the

programme. The light flashes.

2. Select the new programme (with temperature),

any options and another spin speed if you want.

3. Press the “Start/Pause” button again.

The new programme continues at the same

position where the previous programme was

interrupted. Do not add detergent for this

programme.

CANCEL (RESET) A RUNNING PROGRAMME

BEFORE THE END

The “Reset” button cancels a programme before

the end.

•

Press the “Reset” button for at least 3 seconds.

Any existing water is drained out before the

door can be opened.

SELECT ANY DESIRED OPTION

Push the button(s) of any option(s) desired - the

respective indication lamp lights up.

When the combination of programme and

additional option(s) is not possible, the indication

lights switch off automatically.

Unsuitable combinations of options are deselected

automatically.

“Intensive rinse” button

• More water is added and rinse cycle is

prolonged.

• This option is particularly suitable for areas with

very soft water, washing baby linen and helps

people with allergies.

“Spin speed reduction” button

• Reduces the predetermined automatic

maximum spin speed to treat your laundry

more gently.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polar PFL 1009 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polar PFL 1009

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info