Bedienungsanleitung Polar RS800CX (Seite 34 von 68) (Englisch)

464066

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

new sensor? is displayed.

• If your sensor is already taught, select No.

• To teach a new sensor, make sure that there are no other s3/s3+ stride sensors or G3/G5 GPS sensors

nearby (40 m/131 ft) and then select Yes.

To return to time mode, press and hold the STOP button.

Altitude

The training computer converts measured air pressure into an altitude reading. Change the settings of the

altimeter in the Altitude menu. You can calibrate the altimeter manually or automatically.

Set the altitude function on or off

Select Settings > Features > Altitude > On / Off

Calibrating the Altitude Manually

Select Settings > Features > Altitude > Calibrate > set the altitude of current location

If the altitude of your location differs significantly from the displayed altitude value Calibrate to xx? is

displayed.

• Yes: Altitude calibrated to xx is displayed.

• No: Altitude calibration canceled is displayed. The last altitude value stored in the training computer’s

memory is applied.

Calibrate the altitude to ensure it remains accurate. Set the reference altitude whenever a reliable

reference, such as a peak or a topographic map, is available or when at sea level.

Calibrating the Altitude Automatically

Select Settings > Features > Altitude > AutoCalib > On / Off

When automatic calibration is on, the last altitude value stored in the training computer’s memory is

applied when exercising. This feature is especially useful if you always start a session in the same

environment. If automatic calibration fails, you are not in the usual environment and will need to calibrate

the altitude manually.

Altitude calibrated to xx m/ft indicates that calibration has succeeded. If Altitude calibration failed is

displayed, re-calibrate the altitude.

Recording Rate

Select Settings > Features > Rec.rate > 1 / 2 / 5 / 15 / 60 sec

The training computer can store your heart rate, speed/pace,* and altitude in 1, 2, 5, 15 or 60 second

intervals. A longer interval gives you more recording time, while a shorter interval allows you to record

more heart and other data. This enables accurate data analysis using the software.

A shorter recording rate consumes the memory of the training computer more rapidly. The remaining

recording time is displayed on the lower row when setting the rate. Default recording rate is 5 seconds.

When less than 30 minutes of maximum recording time is left, the recording rate changes automatically to

longer recording time (1s > 2s > 5s > 15s > 60s). This will maximize the time to record exercise data.

When the session ends, the current recording rate remains as default.

The following table shows the maximum recording times for each recording rate. Note that recording rate

might change when there is less than 30 minutes of recording time left.

ENGLISH

34 Settings

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polar RS800CX Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polar RS800CX

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info