622065
13
Zoom out
Zoom in
Vorherige Seite
1/25
Nächste Seite
Adjusting the volume level
Press the combined VOL-SQ button once. Now you have 10 seconds
time to select the desired speaker volume by means of the UP-DOWN
keys. You can see in the display the bar graph in the lowest line showing
the selected volume steps:
Adjusting the squelch level
The squelch of a two way radio shall suppress undesired noise on channels or frequencies
where just no receiver signal is present. As soon as a signal will be received, the squelch
opens and the loudspeaker will reproduce the audio signal. The squelch can be adjusted
from very sensitive (or even open) to more tight levels, where the radio has a certain im-
munity against interference or far away signals. You can select the squelch setting as you
did it with the volume.
Press the combined VOL-SQ button twice. Now you have 10 seconds time to select the
desired squelch level by means of the UP-DOWN keys.
You can see in the display the bar graph in the lowest line showing the selected volume
steps:
Please note that in the maximum sensitive position the squelch can remain open. This po-
sition can be used in cases, where the received signal should be very weak.
But the correct position of the squelch level is important during scanning, because an open
squelch means automatically a scan or search stop. So you should decide which is the best
setting dependent on your present local position.
The best setting can also change with your antenna environment. If you are in an area with
strong interference signals, it may be necessary to keep the squelch more closed than in a
rural area far away from transmitting stations.
Short introduction into “Searching Frequencies” and “Scanning Channels”
The first thing you do with the scanner during first time use is to search for busy frequen-
cies in the selected band(s).
If you are in Germany, you may note that the scanner offers you a special German prepro-
grammed band plan setting for German networks. The reason is that in Germany some ra-
dio services use different channel spacing and frequency offsets compared to other countri-
es. Our unique pre-programmed search bands make it very easy to find the transmissions
there, because the scanner starts immediately with the correct settings.
Searching frequencies
Searching means simply checking a certain band or frequency range for transmis-
sions. If you do not know where to find stations, just start at one band and continue
the search.
Scanning channels
Scanner specialists talk about scanning, if you let the scanner only check previously sto-
red frequencies for activity.
Stored frequencies are called channels.
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Polmar RX-5 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info