Bedienungsanleitung Polti Vaporella Forever 1905 Eco Program (Seite 6 von 8) (Englisch)

648755

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

VAPORELLA FOREVER 1905 ECO PROGRAM

ENGLISH

PREPARATION FOR USE

• Pull up the self-refilling tank lid (1) (Fig. 1) and

fill the tank with 1,2l of water, making sure it

does not overflow. Close the lid.

Ordinary tap water may also be

used.However, since water contains lime-

stone by nature, which may cause scaling in

the long run, we recommend using a 50/50

mixture of tap water and demineralised water

or treated with softening systems. To use tap

water only and avoid scale formation, we re-

commend the addition of the special natural

scale removal agent Kalstop FP 2003.

Do not use demineralised water alone, but

mix it with tap water as described above.

Never use distilled

water or scented water.

• Slowly pull out the power cable (9) to the de-

sired length as shown in (fig. 2).

• Connect the cable plug to an earthed power

supply of the correct voltage.

• Press the ON/OFF switch (2). The ON indica-

tor light (A) and the “Iron heating” indicator li-

ght (11) will turn on.

• The sound emitted on switching on your ap-

pliance and periodically during use, is due to

the water refilling system and is quite normal.

INSTRUCTIONS FOR USE

Check the manufacturer’s label on the garment,

and interpret the symbol on the label as follows:

• It is best not to use steam when ironing silk or

synthetics, as iron temperature and pressure

will be enough to ensure good results. Use the

WOOL setting if you wish to iron particularly

delicate fabrics (synthetics and silk) with

steam.

• To optimise ironing time, iron the most deli-

cate fabrics (SYNTH/SILK settings) before

heavier fabrics. If you do it the other way

around, even if steam production is not

stopped, you will have to wait for the iron and

the boiler to cool down to the selected iron

temperature and steam pressure.

Check, based on the following table, the most

appropriate type of ironing:

DRY IRONING

Adjust the selection dial (6) to the SYNT SILK

DRY position.

Wait until the iron heating light (11) turns off.

STEAM IRONING

Set the correct programme by turning the selec-

tion dial (6) corresponding to the type of fabric to

be ironed (Fig.3).

• After setting the desired programme, the

steam ready light (B) flashes. (except if using

the SYNT SILK DRY programme, in which

case the boiler remains off).

• Before starting to iron, wait for the steam pres-

sure indicator (B) to remain on fixed and the

“Iron heating” indicator light (11) to go out.

• Push the button (10) on the iron to release

bursts of steam from the holes on the sole-

Ironing instructions

given on the label

Type of fabric:

Linen

SETTING

Ironing instructions

given on the label

Type of fabric:

Cotton

Denim

SETTING

Ironing instructions

given on the label

Type of fabric:

Wool

Fibres

SETTING

Ironing instructions

given on the label

Type of

fabric:

Acetates

Acrylic

Velvet

Nylon

Silk

Viscose

Polyester

SETTING

VL FOREVER 1905 ECO P. M0S10166 1S02_7:FEV 1000-950.qxd 09/03/2012 9.52 Pagina 29

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polti Vaporella Forever 1905 Eco Program Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polti Vaporella Forever 1905 Eco Program

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info