Bedienungsanleitung Polti Vaporella Forever 670 Eco (Seite 12 von 16) (Englisch)

648735

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

the rubber cover. Unscrew the cap of the boi-

ler situated on the bottom of the appliance

(14) with a suitable screwdriver.

10.4 Use the funnel to pour 250 ml of cold wa-

ter into the boiler (15).

10.5 Rinse out the boiler and pour the water

away into the sink or into a container for col-

lecting dirty water. If the water is very dirty,

repeat the operation until it is clean.

10.6 Put 100 ml of water in the boiler and

screw back the cap. Make sure that the seal is

in and the cap is screwed on properly.

10.7 Fill the water tank again and put the cap

on.

10.8 Turn the appliance on again.

Before ironing, release steam into the sink or

another container and check that the steam is

clean. This should take a few seconds.

10.9 Resume ironing normally.

11. REPLACEMENT BOILER CAP GA-

SKET (not supplied)

If the gasket of the boiler cap is damaged, re-

place it with the specific spare part, as descri-

bed below:

11.1 Unplug the appliance and let it cool down

for 2 hours at least, if it is hot.

11.2 Empty the water from the tank to prevent

leaking.

11.3 Turn the appliance upside down and lift

the rubber cover. Unscrew the cap of the boi-

ler situated on the bottom of the appliance

(14) with a suitable screwdriver.

11.4 Remove the damaged washer.

11.5 Insert the new gasket and push it in place

(15).

11.6 Screw the boiler cap back on, making sure

that it is correctly screwed on and replace the

rubber cover.

The spare gasket can be purchased from

authorized Polti Service centres (check on

www.polti.com for the updated list).

12. STORAGE

12.1 Turn off the appliance and disconnect

from the mains electricity.

12.2 Wait for the appliance to cool down com-

pletely before storing it.

12.3 Empty the water tank.

12.4 Place the tube into the hook on the side

of the unit (17).

12.5 Only model Vaporella Forever 670 Eco it

is possible to lock the iron so that the Vapo-

rella can be carried by lifting it with the hand-

le of the iron (18).

To lock the iron it must first be set on the rear

part of the rest mat (19), then lift the iron lock

located on the front part of the rest mat (20).

To release the iron return the iron lock to the

original position by pushing it downward.

WARNING: Do not exceed the quantity of

water recommended and pour it slowly into

the boiler, paying attention not to let it over-

flow.

Make sure to firmly hook the iron to prevent

it falling accidentally.

WARNING: Risk of scalding! When accessing

the boiler (removing the cap, ﬁlling up,

emptying), ensure that the appliance is swit-

ched off at the power switch and disconnec-

ted from the mains for at least two hours.

WARNING: Steam.

Risk of scalding!

ENGLISH

| 24 |

VL FOREVER 670-675 PRO - M0S10320 - 1P05:FEV 1000-950.qxd 10/06/2015 10.06 Pagina 24

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polti Vaporella Forever 670 Eco Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polti Vaporella Forever 670 Eco

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info