4
REAR PANEL
23. IEC Mains power inlet
24. 24V dc power terminals
25. Speaker output terminals Zone 1 and Zone2
26. Line output Zone 1 and Zone 2
27. Line 4 input (2x RCA)
28. Line 3 input (2x RCA)
29. Microphone 3 or Line 2 input 6.3mm jack
30. Microphone 2 or Line 1 input 6.3mm jack
31. Dip switch
32. Microphone 1 XLR input
DIP SWITCHES
Adjacent to the XLR microphone input for channel 1 is a bank of 4 DIP switches (31). The right-hand
switch is marked ‘VOX’, which sets priority for Mic.1. When this is switched on, any sound through Mic.1
will temporarily mute other inputs.
The next DIP switch enables +20V phantom power on the Mic.1 XLR input. Some condenser
microphones require this phantom power to operate.
The 2 remaining DIP switches are used to set channels to Mic or Line level.
Noted: Be sure to make these DIP switch settings when the amplifier is switched off. Making any changes when the amplifier is
powered up may cause loud bangs through the system which can damage the speakers.
SPEAKER OUTPUTS
The PRM1202 has a separate speaker output for each zone (25) connected via a single terminal block.
Each zone output can be used to power either 100V line speakers or 8Ω speakers.
These configurations cannot be used together, so it is important to decide which will be used at the start.
DC INPUT
The PRM1202 can be operated by 24Vdc power for mobile applications (boats, fairgrounds etc.)
For this type of application, connect the 24Vdc power source to the DC input terminals on the rear panel
(24).
CONNECTING WITH BT
1. Activate the BT-function on your device (Mobile phone, tablet etc.) from which you want to play the
music. See the operating instructions for that device.
2. Press the “BT” button and activate BT-function.
3. Select “PRM-AMPLIFIER” on your BT-device and make the BT-connection
If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.
