Bedienungsanleitung Power Dynamics PDA 8A (Seite 6 von 12) (Deutsch, Englisch, Holländisch, Spanisch)

506161

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

6 - 12

PRODUCT FEATURES

General

• Integrated high power amplifier

• High efficient low-mid woofer

• Line and mic input with Bass and Treble

Controls

• Line output allows daisy chaining of additional

speakers

• High power dynamic horn driver

• Wide dispersion directivity horn

• Stand mounting with 35mm pole socket

• ABS scratch-resistant housing

• Compact speaker system for easy transport

Recommended for

• Bars

• Restaurants

• Small theatre

• Karaoke

• Fitness

• Conference rooms

• Small halls

• Stage monitoring

INPUT PANEL

1. Balanced input connector MIC (PDA-8A: 6.3mm Jack or PDA-10A XLR-6.3mm Jack)

2. Volume control for MIC

3. Line input for audio input source e.g. mixer, CD player, etc

4. Balanced XLR line input

5. Volume control for Line Input

6. Tone control Bass and Treble

7. Output connector (line out). For connection to a second active speaker box.

8. Clip indication. These LED will light up when amplifier are on max power. It can occur that these LED

will lit up now and then, this is not a problem. But if it lights up continually you need to adjust the volume

down, otherwise permanent damage to equipment might occur

9. Power Indication. This clear green indicator will light when the amplifier is turned on.

10. On/Off Switch: For switching the speaker on and off. Always adjust the volume down to its minimum

before switching this speaker on.

11. Mains Power Connector / Fuse. This main fuse secures the speaker against defects. Replace this only

with a fuse of same type and value.

TROUBLESHOOTING

One certain method of determining if a speaker is faulty is to substitute a speaker that is known to work

correctly for the suspected problem speaker. If the “normally correct speaker” is experiencing the same

difficulties or problems as the suspected problem speaker, use the information below to isolate the problem.

No output

Possible cause / Action:

Speaker cables, Reseat all connectors, Inspect cable for damage, Inspect wire or connector for stray strand

that may short

Intermittent

Possible cause / Action:

Poor connections. While it is possible for a faulty speaker to exhibit intermittent output, it’s more likely that an

output cable/connector is the problem. Reseat all connectors

Constant noise, buzzing and/or humming

Possible cause / Action:

Any constant noise originates in the amplifier, mixer, signal processing, source device in the signal devices,

or line-level wiring. Check and correct system grounding as required. Chain check for noisy sources or

electronic components. Check wiring for shielding.

Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit.

This would also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by

inappropriate use or disrespect of the warnings contained in this manual. Tronios cannot be held responsible for

personal injuries caused by a disrespect of the safety recommendations and warnings. This is also applicable to all

damages in whatever form.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Power Dynamics PDA 8A Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info