Bedienungsanleitung Powerfix Profi PLBS 2 A1 - IAN 277698 (Seite 8 von 44) (Deutsch, Englisch, Holländisch, Französisch)

706369

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

│

5 ■

PLBS 2 A1

■ Do not open, dismantle, pierce, modify or throw

batteries and avoid unnecessary impacts.

■ Do not expose batteries to naked ﬂames or

temperatures of above 50°C. Do not store bat-

teries in hot locations and do not expose them

to direct sunlight.

■ Never immerse batteries in water or other liq-

uids.

■ Never place batteries in a microwave or high-

or low-pressure container.

■ Improper use may cause ﬂuid to leak out of the

battery. If this happens, avoid contact with the

ﬂuid. If contact occurs, ﬂush the aﬀected area

with water. Seek additional medical help if any

of the ﬂuid gets into your eyes. Leaking battery

ﬂuid can cause skin irritations or burns.

■ Incorrect use can cause vapours to escape that

can cause damage to health and respiratory

irritation. Ventilate the area immediately with

fresh air and obtain medical advice.

■ Incorrect handling can lead to a short-circuit or

an explosion!

■ Dispose of used batteries and defective appli-

ances in compliance with legal requirements.

Appliance-speciﬁc safety instructions

■ Keep the appliance away from wet or dampness.

Water getting into the appliance may lead to

an electric shock.

■ Do not work with this appliance in water or

other liquids.

■ Keep ﬁrm hold of the appliance and do not

drop it.

■ Avoid unintended switching on. Check that the

appliance is switched oﬀ when you insert a bat-

tery. Inserting batteries into the appliance while

it is switched on can cause accidents.

■ Do not block oﬀ the openings on the appliance.

Before use

Inserting/replacing the batteries

Vacuum pump

♦ To insert batteries, open the battery compart-

ment

by turning the cover anticlockwise and

removing it.

♦ Insert the supplied batteries or two equivalent

AA batteries. Observe correct polarity when

inserting batteries to avoid damage!

♦ Replace the cover and close it by turning it in

a clockwise direction until it clicks ﬁrmly into

place.

Line laser

♦ To insert the batteries, ﬁrst remove the appli-

ance from the protective cover

♦ Open the battery compartment cover

on the

underside of the line laser and remove it.

♦ Insert the supplied button cells or three equiva-

lent type LR44 button cells. Observe correct

polarity when inserting batteries to avoid dam-

age.

♦ Replace the battery compartment cover

and

close it so that it clicks ﬁrmly into place.

Using the protective cover/wall

bracket

The protective cover is intended primarily to

protect the soft seals from damage when the

appliance is not in use.

♦ After use, always replace the protective cover

♦ You can attach the protective cover

to a pre-

determined attachment point on the wall with a

screw and use it as a wall bracket.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerfix Profi PLBS 2 A1 - IAN 277698 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info