749037
8
Zoom out
Zoom in
Vorherige Seite
1/17
Nächste Seite
7
B Remote start
1. Please make sure the fuel shutoff valve to the ON position, the engine
switch to theRUN position
2. Press the ON button on the remote control (key fob) twice.
3. Please wait 10 seconds and repeat again if it couldn’t start.
4. Warm up the engine without a load for a few minutes.
2
USING ELECTRIC POWER
1. AC APPLICATION
(a) Check the AC pilot lamp for proper voltage.
(b) Turn off the switch(es) of the electrical appliance(s) before connecting to
the generator.
(c) Insert the pulg(s) of the electrical appliance(s) into the receptacle.
CAUTION:
Be sure the electric apparatus is turned off before plugging in.
Be sure the total load is within generator rated output.
Be sure the socket load current is within socket rated current.
The economy control switch must be turned to OFF when using electric
devices that require a large starting current, such as a compressor or a submergible pump.
2
OVERLOAD INDICATOR LIGHT
The overload indicator light comes on when an overload of a connected electrical device is detected, the inverter unit
overheats, or the AC output voltage rises. The electronic breaker will then activate, stopping power to the generation in
order to protect the generator and any connected electric devices. The output pilot light (green) will flicker and the overload
indicator light (red) will turn on, then the engine will stop running. If so please follow the following steps:
(a) Turn off any connected electric devices and stop the engine
(b) Reduce the total wattage of connected electric devices within the application range.
(c) Check for blockages in the cooling air inlet and around the control unit. If any blockages are found, remove.
(d) After checking, restart the engine.
CAUTION:
The generator AC output automatically resets when the engine is stopped and then restarted.
The overload indicator light may come on for a few seconds at first when using electric devices that require a large
starting current, such as a compressor or a submergible pump. However, this is not a malfunction.
ENGINE
SWITCH
ENGINE
SWITCH
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Powerkick 6000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Powerkick 6000

Powerkick 6000 Bedienungsanleitung - Holländisch - 17 seiten

Powerkick 6000 Kurzanleitung - Holländisch - 2 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info