Bedienungsanleitung Powerplus pow xq 5205 (Seite 8 von 11) (Englisch)

389264

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

POWXQ5205 EN

9.1 Drilling in Metal

 For maximum performance, use high speed steel bits for metal or steel drilling.

 Turn drilling mode selector to drilling mode.

 Use a center punch to mark the hole location on the workpiece.

 Begin drilling at a very low speed to prevent the drill from slipping off the starting point.

 Maintain a speed and pressure which allows cutting without overheating the bit. Applying

too much pressure will: overheat the drill, wear the bearing, bend or burn bits, produce off-

center or irregular shaped holes.

 When drilling large holes in metal it is recommended to drill with a small drill at first, then

finish with a larger drill, also, lubricate the drill with oil to improve drilling action and

increase drill life.

9.2 Drilling in Wood

 For maximum performance, use high speed steel bits for wood drilling.

 Turn the drilling mode selector to drilling mode.

 Secure the workpiece to prevent it from turning when drilling.

 Begin drilling at a very low speed to prevent the drill from slipping off the starting point.

Increase the speed as the drill bites into the material.

 When drilling through holes, place a block of wood behind the workpiece to prevent

ragged or splintered edges on the back side of the hole.

 Do not lock the trigger in the “on” position when the drill may need to be stopped suddenly.

9.3 Drilling in Masonry/concrete

Wear ear protectors when impact drilling. Exposure to noise can cause

hearing loss.

 For maximum performance use tungsten carbide-tipped masonry impact bits when drilling

holes in brick, tile, concrete, etc.

 Turn the drilling mode selector to impact mode.

 Apply light pressure and medium speed for best results in brick.

 Apply additional pressure and high speed for hard materials such as concrete.

 When drilling in tile, practice on a scrap piece to determine the best speed and pressure.

 Hold power tool by insulated gripping surfaces when drilling in walls/ceilings/floors. The

drill may contact hidden wiring or its own cord.

A drill contacting a "live" wire may make exposed metal parts of the power

tool "live" and could give the operator an electric shock.

9.4 stop drilling immediately when :

If any of the following events occur during normal operation, the power supply should be shut

off at once and tool thoroughly inspected by a qualified person and repaired if necessary:

 The rotating parts get stuck or speed drops abnormally low

 The tool shakes abnormally accompanied by some unusual noise.

 The motor housing gets abnormal hot.

 Heavy sparks occur around the motor area

10 CLEANING AND MAINTENANCE

Attention !Before performing any work on the equipment, pull the power

plug.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus pow xq 5205 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus pow xq 5205

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info