Bedienungsanleitung Powerplus POW902 (Seite 7 von 11) (Englisch)

582177

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

POW902 EN

 Always wind the cable as shown in Fig. 4.

Note: When replace the wire rope, be sure to pull rope into the square hole

of rope drum, and then pull it out from the round hole. With that wind the

rope two circles and then pull it to the edge which is side of rope drum and

fix it.

 The cable hoist is operated using the remote control (14). When operating the upper

position of the switch, the load is hoisted up. When operating the lower position, the load

is lowered. Never switch directly from hoisting to lowering or vice versa. Always stop the

cable hoist prior to changing directions.

 Operate the Emergency switch (15) to immediately stop the cable hoist in case of an

emergency and to secure against restart. To reset the device to operational status, first

turn the Emergency switch (15) clockwise, which will unlock the Emergency switch (15).

The cable hoist is now operational.

 The cable hoist is designed with limit configuration to limit stop. When load hook (12) is

hoisting up to topmost position, the stopper (10) touch the lift limit bracket (8), the micro

switch of lift limit bracket (8) can cut off the circuit and make the motor stop to insure the

safety of operations. When load hook (12) is lowering down nearly to use up the cable (7),

the micro switch of down limit bracket (9) start work and cut off the circuit and make the

motor stop.

Attention! If the cable has been unwound to the point where the red micro

switch is visible, the cable hoist must be stopped. Under no circumstances

should the cable be unwound past this point'

 If the cable hoist cannot hoist a load immediately, switch it off immediately to prevent

damages and accidents.

 Please be sure that the load is securely fastened to the load hook (12-13). Maintain the

largest possible distance to the load and steel cable (7) during operation.

 Upon lowering a load, please remember that the cable hoist may still unwind a few more

centimetres after it was stopped. Therefore, please stop in sufficient time.

 Please be sure that the steel cable (7) cannot be moved more than 15° to the side.

 The cable hoist can be operated with a single or double cables, therefore the permissible

rated load, see Technical Specifications, can vary.

 After unpacking the items, check to make sure that all pieces and accessories correspond

with the directions. Check to see if the cable hoist has any dents or damage, if the cable

connections have any defects and if the motor shows any signs of rain or water damage.

 The cable hoist uses a single-phase energy power supply. The nominal voltage is 230V +

20%, the nominal frequency is 50Hz + 1%. The motor must be safely grounded. In the

circuitry of the power supply an over-current protection must be installed.

 After connecting the power supply, the pulley can then be raised and lowered in Jog-

mode. One can raise and lower start-up during a dry-run. First when the up and down

movement is stable and the brakes work flawlessly, once can test the pulley with a dummy

load.

9.1 Intermittent rating

This machine is designed for operating type S3 20% - 10 min (periodic intermittent operation).

The relative duty cycle is 20%, which means that the device can be operated at rated load for

2.0 minutes during each operating cycle and must then be switched off for 8. 0 minutes to cool

off. The device can therefore be continuously used for a duration of 20% of the total operating

cycle of 10 minutes at rated load.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POW902 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POW902

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info