POWDP2580 EN
Copyright © 2022 VARO P a g e | 12 www.varo.com
Warning! You should replace the table insert (6) immediately whenever it is
worn or damaged (see 9.2).
Warning! The work to change and align the saw blade (4) must be carried
out correctly.
9.6 Putting away loose parts (Fig. 1)
When not in use, the cross stop (14), push stick (3) and the two wrenches (30, 31) can be
secured as shown in Fig. 2.
9.7 Connection for dust extractor (Fig. 11, 12a-b)
A connection for a dust extractor is provided on the T- extractor adapter on the housing (16)
and on the saw blade guard (2).
9.7.1 Dust extraction using a wet & dry vac. (Fig. 11)
▪ A wet & dry vac is not supplied with the product and is available as an accessory.
▪ Connect the wet & dry vac to the T-extractor adapter on the housing (16).
9.7.2 Dust extraction using a vacuum extraction system and extractor adapter set.
▪ The product is supplied with a T-extractor adapter set with suction hose (a) and adapter
(b) or a vacuum extraction system.
▪ Using a cross tip screwdriver, undo the screw on the cap (16) on the saw blade guard
(2).
▪ Remove the cap (16) from the saw blade guard (2).
▪ Connect the adapter (b) to the extractor adapter on the housing (16).
▪ Connect the saw blade guard (2) and the adapter (b) to the suction hose (a).
▪ A vacuum extraction system can now be connected to the 100 mm diameter of the
adapter (b).
10 OPERATION
10.1 Charging the battery pack
The battery pack for this tool is supplied in a low charge condition to prevent possible
problems, therefore, you have to charge the battery before first use.
Note: Batteries will not reach full charge the first time they are charged.
Allow several cycles for the item to fully charge. The battery should only be
charged indoors.
After normal use, about 1 hour of charging time is required for the battery to be fully charged.
The battery pack will become slightly warm while charging, this is normal and does not
indicate a problem.
Do not place the charger in an area of extreme heat or cold. Best is at normal room
temperature. When the battery becomes fully charged, unplug your charger from the power
supply and remove the battery pack from the charger.
Note:
1. Allow the battery pack to cool completely before charging.
2. Inspect the battery pack before charging, do not charge a cracked or leaking battery
pack.
