POWDP35170 EN
Copyright © 2021 VARO P a g e | 9 www.varo.com
Note: If the protective guard cannot be fixed firmly by the lock lever (4), use
a hexagon wrench to tighten the hexagon nut.
Warning: the protective guard must be positioned to protect the user if the
disc shatters during use.
9.3 Replacing the grinding disc (Fig. 6-7)
Beware – a disc which has been used may be very hot!
Warning: prior to assembly and adjustment always pull out the battery pack
from the grinder body.
▪ Depress and hold down the spindle lock button (2) to secure the spindle.
▪ Turn the output spindle until it locks.
▪ Remove the outer flange and backing flange by using the two-hole spanner provided.
▪ Fit the desired disc (9) on the spindle and replace the outer flange and backing flange.
Release the spindle lock.
Important! Only ever press the spindle lock when the motor and grinding
spindle are at a standstill!
You must keep the spindle lock pressed while you change the wheel!
Switch the grinder on using the lock/on switch (3) and let it run for 30 seconds to check that it
is working correctly and that there are no abnormal vibrations. Stop the grinder immediately if
heavy vibration occurs, and investigate the cause.
For grinding disc and cutting wheel with a thickness up to approx. 3 mm, screw on the outer
flange with the flat side facing the grinding disc or cutting wheel.
10 OPERATION
10.1 Switch on/off (Fig. 8)
Before engage the ON/OFF switch button, check that the grinding disc is
properly fitted and run smoothly, the outer flange is well tightened.
▪ Connect the battery pack onto the angle grinder body.
10.1.1 Switching on
Push the lock/on switch (3) forward, afterwards depress the lock/on switch (3) fully.
10.1.2 Switching off
Release the lock/on switch (3). The switch will return automatically to the locked position.
The wheel continues to rotate after the tool is switched off.
