POWDP6040 EN
Copyright © 2020 VARO P a g e | 8 www.varo.com
NOTE: Remove battery pack from charger stand which use your thumb or
fingers, press the battery’s release button in and pull the battery pack off at
the same time.
9.2 Battery capacity indicator (Fig. 1a)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button (16). Before using the machine, please press switch trigger
to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged.
2 LED’s are litt: Battery 60% charged.
1 LED is litt: Battery almost discharged.
9.3 Inserting and removing the battery (Fig. 2)
WARNING: Before making any adjustments ensure the drill is switched off
with the direction of rotation selector in the centre position.
▪ Hold the tool with one hand and the battery pack (17) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
9.4 Switching on and off
▪ To switch the machine on, set the on/off switch (1) to “I”.
▪ To switch the machine off, set the on/off switch (1) to "0".
9.5 Vacuuming up waste material
▪ Mount the tube (10) to the hose (8).
9.6 Vacuuming up dust released from an electrical tool
▪ Connect the hose with the handgrip (9) directly to the dust extraction outlet of the electrical
tool.
9.7 Vacuuming up liquids
▪ Make sure the inside of the tub (5) is clean and free from dust.
▪ Mount the tube (10) to the handgrip of the hose (9). Leave an opening at the top of the
universal nozzle in order to enable the air flow.
9.8 Blowing
▪ You can also use this tool to blow away dust, leaves etc. Disconnect the hose from the
hose connection (6) on the side of the tub and connect the hose to the special connection
for the blow function (14) on top of the tool.
9.9 Emptying the tub
▪ Switch off and remove battery.
▪ Remove the motor housing (2).
▪ Empty the tub (5).
