POWDP75300 EN
Copyright © 2022 VARO P a g e | 9 www.varo.com
The battery pack will become slightly warm while charging, this is normal and does not
indicate a problem.
Do not place the charger in an area of extreme heat or cold. Best is at normal room
temperature. When the battery becomes fully charged, unplug your charger from the power
supply and remove the battery pack from the charger.
Note:
▪
Allow the battery pack to cool completely before charging
▪
Inspect the battery pack before charging, do not charge a cracked or leaking battery pack.
9.2 Charging indication (14) (Fig. B)
Connect the charger to the power outlet socket
▪
Solid green: ready to charge
▪
Flickering red: charging
▪
Solid green: charged
▪
Solid green and red: battery or charger damaged
Note:If the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
▪
Frequently monitor the charger and battery pack while connected
▪
Unplug the charger and disconnect it from the battery pack when finished.
▪
Allow the battery pack to cool completely before using it.
▪
Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool
down to room temperature before charging. This will extend the life of
your batteries.
NOTE: Remove the battery pack from the charger with your hands only,
press the battery’s release button in and pull the battery pack off at the
same time.
9.3 Battery capacity indicator (Fig. A)
▪
There are battery capacity indicators (11) on the battery pack, you can check the capacity
status of the battery if you squeeze the button for battery capacity indicator (12).
▪
Those 3 LED’s show the status of the capacity level of the battery:
3 LED’s are lit: Battery fully charged
2 LED’s are lit: Battery 60% charged
1 LED is lit: Battery almost discharged
9.4 Inserting and removing the battery (Fig. A)
WARNING: Before making any adjustments ensure the tool is switched off
or remove the battery pack
▪
Hold the tool with one hand and the battery pack (9) with the other.
▪
To install: push and slide the battery pack into the battery port, make sure the release
button (10) on the rear side of the battery snaps into place and the battery is secure before
beginning operation.
