Bedienungsanleitung Powerplus POWDPG7545 (Seite 8 von 12) (Englisch)

725650

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

POWDPG7545 EN

9 ASSEMBLY

The grass trimmer is supplied with some components not assembled. To assemble these

proceed as follows:

9.1 Mounting the guard

 Fix the safety guard to the trimmer head making sure the sides are located into the

grooves on the trimmer head.

 Secure the safety guard onto the trimmer head with the screws provided.

 Remove the warning label sticker from the cutter blade immediately after mounting the

guard.

Caution! During this operation beware of the line cutter blade. You may be

wounded.

Caution! Never use the grass trimmer without the guard. It is vital for your

and other peoples’ safety and for the good working order of the trimmer.

The failure to observe this safety regulation is not only dangerous but also

annuls the guarantee terms.

9.2 Install edge guide

 Spread edge guide arms apart, then push ends into holes on housing.

 Use the edge guide to limit striking objects with the Line while trimming nearby.

 Flip the edge guide up out of the way when not in use.

9.3 Height adjustment (Fig. 2)

 To adjust the height, simply rotate and loosen the collar extension lock knob (5) as arrow 1

shown and to extend or retract the extension tube (6) as arrow 2 shown.

 Tighten the extension lock knob (5) to lock the tube on the selected position.

9.4 Setting the auxiliary handle (Fig.3)

 Squeeze the adjustment button of auxiliary handle (4).

 Turn the auxiliary handle (3) until the most balanced and most comfortable position.

 Then tighten the adjustment button of auxiliary handle (4) to the chosen position.

9.5 Adjustment the cutting angle (Fig.4)

Your Trimmers has a 2-positions cutting head. This setting allows you to work effectively at a

comfortable working angle. It can cut accurately around the flower beds, under bushes,

around trees and fence posts etc.

To change the angle, simply press the a head angle button (7) of the cutting head, to the

engine block to the desired position, then release the button.

Warning: remove the battery pack from the trimmers before handling

setting.

Warning: Always wear safety glasses. Never lean over the cutting head.

Stones or debris can bounce or be thrown into eyes and face and blind you

or serious injury. To use the machine, note the following points: Put on

heavy clothing and eye protection. Hold the front handle with one hand and

the auxiliary handle with the other hand. Store unit below the waist level.

Have the unit from right to the left so that residues are always projected on

the side opposite you. While avoiding bending over, keep the section

parallel to the ground wire (or perpendicular to trim edges) and prepared

the material to be cut (but not touching).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POWDPG7545 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POWDPG7545

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info