POWDPG80400 EN
Copyright © 2021 VARO P a g e | 10 www.varo.com
▪ Never blow through nozzles or other components by mouth.
▪ Avoid contact with plant control chemicals – immediately change clothing contaminated
with plant control chemical.
▪ Do not spray in windy conditions.
▪ Too high or too low a pressure or unfavorable weather conditions can result in the wrong
solution concentration. Overdosing may damage plants and the environment. Underdosing
may result in unsuccessful plant treatment.
▪ In order to reduce the risk of damage to the environment and plants, do not operate the
sprayer: i. pressure is too high or too low
ii. in windy conditions
iii. in direct sunlight
▪ In order to reduce the risk of accidents and damage to the sprayer, never operate the
sprayer with: i. flammable liquids
ii. viscous or sticky liquids
iii. caustic or corrosive chemicals
iv. liquids hotter than 50°C
▪ Avoid use the product in cold winter since the solution may be freeze.
10.4 Transportation and storage
▪ Remove the battery pack.
▪ Ensure that all parts are clean and dry.
▪ Clean all foreign materials from the product.
▪ Drain all spray materials from the spray tank before storage and transportation.
▪ After each use, check all parts of the unit for leaks. Return the product to an authorized
service center for repair if has any.
▪ The spray wand can be stored in the cradle.
▪ For transportation, secure the product against movement or falling to prevent injury to
persons or damage to the product.
▪ Store the product in a cool, dry and well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden chemicals and de-icing salts. Do not
store outdoors.
11 ASSEMBLY
WARNING: Switch off and remove battery from machine before adjusting or
cleaning!
11.1 Connecting the spray wand to the handle (Fig.4)
▪ Insert the spray wand (2) into the handle (9) as shown.
▪ Slide the o-ring (10) down until it touches the handle (9).
▪ Thread the cap (8) onto the handle (9) and tighten securely.
▪ Rotate the nozzle (1) until it is aligned with the handle (pointing down) and ready for use.
▪ Slide the nut (11) onto the cap (8) and tighten securely.
▪ Pull on the spray wand (2) to be certain it is properly secured.
▪ Place the assembled handle (9) into the handle storage area.
11.2 Attaching the hose (Fig.5-6)
▪ To attach the hose to the tank, slide the nut (11) on the hose (6) away from the hose end.
▪ Insert the hose end into the opening on the tank as shown. Make sure the connection is
secure.
▪ Slide the nut (11) over the opening and hose end. Tighten, but do no overtighten.
