POWE20020 EN
Copyright © 2018 VARO p a g e | 7 www.varo.com
You must keep the spindle lock pressed while you change the wheel !
For grinding wheels up to approx. 3 mm thick, screw on the flange nut with the flat side facing
the grinding wheel.
7.4 Special attention when starting the machine
▪ Clamp the workpiece and make sure that the workpiece cannot slide from under the
machine during the cutting activities.
▪ When working with the machine, always hold it firmly with both hands and provide for a
secure stance.
▪ Always direct the cable to the rear away from the machine.
▪ Insert the mains plug only when the machine is switched off.
▪ Apply the machine to the workpiece only when switched on
Never use the machine for grinding magnesium workpieces.
7.5 Switching on / off (Fig. 6)
▪ Connect the plug to the power supply. The power-on indicator (10) is illumed until the tool
disconnect from the power mains.
Before working with the angle grinder, check that the voltage shown on the
machine’s model plate is the same as the mains voltage being used.
Before engage the ON/OFF switch trigger, check that the grinding disc is
properly fitted and run smoothly, the outer flange is well tightened.
To switch on the angle grinder, press the safety lock-off button (6) downward and squeeze the
ON/OFF switch trigger (5).
When you release the switch trigger, the tool turns off.
Do not let go of grinder until it has stopped running.
The wheel continues to rotate after the tool is switched off.
8 OPERATON MODES
8.1 Grinding
Hold the handle (4) and auxiliary handle (7) firmly and
switch on. Avoid blocking the ventilation slots with your
hand, as this may cause the grinder to overheat. Let the
disc reach full speed. Apply the grinder to the item.
Maximum effect is achieved when the grinder is held at
an angle of 15-30°in relation to the item. Move the
grinder gently along the item. Give the grinder time to
work. It is rarely necessary to press the disc hard against the surface to be worked. Sparks
can occur in the motor compartment during use. This is normal and does not mean the grinder
is defective. Switch off the grinder after use.
