POWE20025 EN
Copyright © 2021 VARO p a g e | 8 www.varo.com
7.5 Switching on / off (Fig. 6)
▪ Connect the plug to the power supply.
Before working with the angle grinder, check that the voltage shown on the
machine’s model plate is the same as the mains voltage being used.
Before engage the ON/OFF switch trigger, check that the grinding disc is
properly fitted and run smoothly, the outer flange is well tightened.
To switch on the angle grinder, press the safety lock-off button (6) downward and squeeze the
ON/OFF switch trigger (5).
When you release the switch trigger, the tool turns off.
Do not let go of grinder until it has stopped running.
The wheel continues to rotate after the tool is switched off.
8 OPERATON
8.1 Grinding Hold the handle (4) and auxiliary handle (7) firmly and
switch on. Avoid blocking the ventilation slots with your
hand, as this may cause the grinder to overheat. Let the
disc reach full speed. The grinder has a speed setting
wheel (10) that can be adjusted according to the
application and material. There are 6 settings for speeds
between 3000 and 12000rpm. Choose a speed setting
when the grinder is not working only and then test the
result. Apply the grinder to the item. Maximum effect is achieved when the grinder is held at
an angle of 15-30°in relation to the item. Move the grinder gently along the item. Give the
grinder time to work. It is rarely necessary to press the disc hard against the surface to be
worked. Sparks can occur in the motor compartment during use. This is normal and does not
mean the grinder is defective. Switch off the grinder after use.
9 FLANGE ARRANGEMENTS WHEN USING DEPRESSED CENTRE
WHEELS/DISCS
9.1 Flange arrangements when using a depressed centre grinding wheel/disc
1 Clamping flange
2 Flange nut 3 Grinding head
4 Wheel/disc
