POWE50002 EN
Copyright © 2020 VARO P a g e | 9 www.varo.com
9.8 Laser
▪ You can switch the laser ON and OFF with the switch (28)
▪ The laser (23) directs a beam onto the workpiece
▪ Extremely precise cuts can be made using the laser function.
9.9 Dust bag
To attach the dust bag (15), fit it onto the dust extraction adapter. When the dust bag is about
half full, remove the dust bag from the tool and empty it.
9.10 Sawing
Make sure the saw blade doesn’t block while you are sawing. It causes
damage to and burning of the motor. If there is a blockade of the saw blade,
please loosen the switch immediately to prevent damage at the motor.
▪ Clamp the work piece firmly.
▪ Set the required horizontal mitre angle or the required vertical bevel angle.
▪ Switch on the power tool.
▪ Move the handle (2) slowly downwards.
▪ Saw trough the work piece.
▪ Switch off the power tool.
▪ Wait until the saw blade (12) has come to a complete standstill before removing the work
piece.
9.11 Sawing special work pieces
Curved or round work pieces need to be secured against slipping.
Make sure there is no gap between the work piece and the fence (5) or the saw table (7).
9.12 Replacing the saw blade (Fig. 2)
Disconnect the tool from the outlet before working on the saw blade.
Wait a while before touching the saw blade. It can be very hot.
The teeth of the saw blade are very sharp.
▪ Pull the mitre saw downwards and lock it in the lowest position by pushing the retaining
pin.
▪ Allow the mitre saw cutting head to rise to the upright position
▪ Loosen the cover plate screw (1).
▪ Press the spindle lock (17)
▪ Tilt the cover plate (1) upwards in order to make the axle bolt (3) accessible.
▪ Press the spindle lock button, holding it in firmly while turning the blade wrench clockwise.
The spindle lock will engage after turning the wrench. Continue to hold the spindle lock
button to keep it engaged, while turning the wrench clockwise to loosen the spindle bolt.
▪ Remove the lock bolt, outer flange (c), saw blade (b) and inner flange (a).
▪ Remove the chips or sawdust from around the spindle and flanges.
▪ Replace the saw blade (the tips of the sawing teeth have to point in the same direction as
indicated by the arrow on the cover) and then reassemble all parts in the reverse order.
▪ Turn the plastic cover back in its original position.
