POWE80090 EN
Copyright © 2018 VARO P a g e | 5 www.varo.com
▪ Connect the black (-) alligator clamp to a non moving metal part of the engine. NOT to the
black (-) negative battery terminal.
▪ Connect the red (+) alligator clamp to the red (+) positive battery terminal.
▪ Switch the ignition on of the vehicle or boat.
▪ Wait a minute or two.
▪ Start the vehicle or boat engine for no more than 5 to 6 seconds.
▪ If the vehicle or boat engine does not start, wait at least 3 minutes before trying again.
▪ Once the engine is running, disconnect the black (-) clamp first and return this cable to its
stored position on the jump start.
▪ Disconnect the red (+) clamp and return this cable to its stored position on the jump start.
▪ Connect your jump start system as soon as possible to the 230V AC adapter/charger and
recharge.
7.2 Compressor operation
Run compressor only for 10 minutes continuously at a time. Then leave off
for 10 minutes for cooling down before using again.
▪ For tire inflation use the universal adapter that is attached permanently to the air hose.
Press the adapter lever up. Place the adapter onto the tire valve system and press the
adapter lever down to lock onto the valve system.
▪ For inflation of leather balls, flotation devices, etc., use one of the nozzles.
▪ Check pressure gauge and determine the desired pressure.
▪ Turn on the power switch.
▪ When the desired pressure is reached turn the compressor switch off.
▪ Remove the adapter from the tire or other item you have inflated.
7.3 Your power station as a power source
▪ Lift up the cover of 12V DC cigarette lighter receptacle (1).
▪ Plug the 12V DC cigarette lighter plug from (13) into the receptacle (1).
▪ Insert the second plug into the appliance you want to use.
The table below gives you an idea of the estimated operation time from a fully charged system.
