POWEBG7540 EN
Copyright © 2018 VARO P a g e | 8 www.varo.com
Caution! Never use the grass trimmer without the guard. It is vital for your
and other peoples’ safety and for the good working order of the trimmer. The
failure to observe this safety regulation is not only dangerous but also annuls
the guarantee terms.
9.2 Height adjustment (Fig. 1)
▪ To adjust the height, simply rotate and loosen the collar extension lock knob (5) as arrow 1
shown and to extend or retract the extension tube (6) as arrow 2 shown.
▪ Tighten the extension lock knob (5) to lock the tube on the selected position.
9.3 Setting the auxiliary handle (Fig. 2)
▪ Squeeze the adjustment button of auxiliary handle (4).
▪ Turn the auxiliary handle (3) until the most balanced and most comfortable position.
▪ Then tighten the adjustment button of auxiliary handle (4) to the chosen position.
9.4 Adjustment the cutting angle (Fig. 3)
Your Trimmers has a 3-positions cutting head. This setting allows you to work effectively at a
comfortable working angle. It can cut accurately around the flower beds, under bushes, around
trees and fence posts etc.
To change the angle, simply press the a head angle button (8) of the cutting head, to the engine
block to the desired position, then release the button.
Warning: remove the battery pack from the trimmers before handling setting.
Warning: Always wear safety glasses. Never lean over the cutting head.
Stones or debris can bounce or be thrown into eyes and face and blind you
or serious injury. To use the machine, note the following points: Put on heavy
clothing and eye protection. Hold the front handle with one hand and the
auxiliary handle with the other hand. Store unit below the waist level. Have
the unit from right to the left so that residues are always projected on the
side opposite you. While avoiding bending over, keep the section parallel to
the ground wire (or perpendicular to trim edges) and prepared the material
to be cut (but not touching).
Warning: Before starting work, make sure that the wire is long enough. Do
not start work before the engine running at full speed.
9.5 Mounting the bracket with two wheels (Fig. 4)
▪ Place the bracket with two wheels (12) shown in picture 5.
▪ Turn the lock screw (7) clockwise and tighten it to lock the edger wheels on the fixed
position.
▪ Remove the edger wheels in the opposite way.
10 OPERATION
If the line is too long when you use the equipment for the first time, the
surplus end of it will be cut by the blade on the guard hood.
Your grass trimmer will work at its best if you observe the following instructions:
▪ Never use the grass trimmer without its safety devices.
▪ Do not cut grass when it is wet. The best results are had on dry grass.
