POWP6081 EN
Copyright © 2020 VARO NV P a g e | 6 www.varo.com
8.3 Temperature adjustment
Temperature can be selected by pressing the plus (“+’) [9] or minus (“-”)[10] button.
▪ Temperature will Increase or decrease 10 by each pushing down. Keep pushing down will
make the temperature setting fast.
▪ After finish setting, the LCD display the current temperature and the arrow shows
temperature is changing in direction of setting, if temperature reachs setting number, the
arrow will disappear.
Note: the arrow will disappear when temperature over 999 in ℉.
Temperature is increasing.
Temperature is decreasing.
The temperature can be adjusted by control the distance between output
and the applied surface. The further distance the lower temperature. Never
stop or dwell in one spot.
8.4 Change temperature display unit
The temperature display unit can be switched between ℉ and ℃ by following steps.
▪ A: press the minus button” ” [10] down, keep pressing and insert the plug to outlet.
The current unit will show on the screen, F or C. F indicates ℉ and C indicates ℃.
▪ B: press down the “ ” button [9] to switch the unit, after seletion pull out the plug.
Let this hot air gun run a few minutes and reach to the setting temperature
before operating.
Prior to assembly and adjustment always unplug the tool
The air temperature can be adjusted to suit a wide range of applications. The table below
suggests settings for different applications.
If you are not sure about the correct setting, start with a low temperature
setting and gradually increase the temperature until you achieve optimum
results
