POWPB20200 EN
Copyright © 2020 VARO P a g e | 9 www.varo.com
For grinding disc and cutting wheel with a thickness up to approx. 3 mm, screw on the outer
flange with the flat side facing the grinding disc or cutting wheel.
10 OPERATION
10.1 Switch on/off (Fig. 9)
Before engage the ON/OFF switch button, check that the grinding disc is
properly fitted and run smoothly, the outer flange is well tightened.
▪ Connect the battery pack onto the angle grinder body.
10.1.1 Switching on
Switch the angle grinder on by depress the rear position of the ON/OFF switch button (4) as
the arrow 1 shows on the Fig. 9 and pushing the switch button forward as the arrow 2 shows
on the Fig. 9 and lock onto the “ON” position.
10.1.2 Switching off
Depress the rear position of the ON/OFF switch button (4), it returns automatically to the
“OFF” position and the tool turns off. Do not let go of grinder until it has stopped running.
The wheel continues to rotate after the tool is switched off.
Note: the switch of this angle grinder has a power-off protection function
that avoids to personal injury and damage after power down because
of sudden start when power on again.
11 USE
11.1 Grinding Hold the handle (3) and auxiliary handle (6) firmly and
switch on. Avoid blocking the ventilation slots with your
hand, as this may cause the grinder to overheat. Let the
disc reach full speed. Apply the grinder to the item.
Maximum effect is achieved when the grinder is held at
an angle of 15-30°in relation to the item. Move the
grinder gently along the item. Give the grinder time to
work. It is rarely necessary to press the disc hard against the surface to be worked. Sparks
can occur in the motor compartment during use. This is normal and does not mean the grinder
is defective. Switch off the grinder after use.
12 CLEANING AND MAINTENANCE
12.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust and dirt.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
