POWPB30100 EN
Copyright © 2021 VARO P a g e | 8 www.varo.com
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
8.2 Removal / insertion of battery (Fig. 2)
WARNING: Before making any adjustments ensure the hedge trimmer is
switched off or remove the battery pack.
▪ Hold the tool with one hand and the battery pack (9) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
8.3 Battery capacity indicator (Fig. 3)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button. Before using the machine, please press switch trigger to
check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged
2 LED’s are litt: Battery 60% charged
1 LED is litt: Battery almost discharged
9 OPERATION
9.1 Replacing saw blades (Fig. 4)
Disconnect the battery pack (9) from the cordless jig saw.
▪ Push transparent blade cover towards the front.
▪ Slide the saw blade (7) into the locating groove with teeth pointing forward. Make sure that
the back edge of the blade fits into the blade clamping holder and then release the blade
cover.
NOTE: Make sure that the back of the saw blade engages in the slot of the
guide roller (6).
▪ Mounting battery pack (9) onto jig saw’s body and runs smoothly before using it to cut any
materials.
9.2 Angle cutting adjustment (Fig 5)
▪ The base plate (11) can be adjusted 45° (left or right) in relation to the saw direction to
facilitate contour sawing.
▪ Loosen the soleplate by pushing the lock lever (14) to the right position, adjust the
soleplate to the desired angle and tight it by pulling the lock lever onto the left (center)
▪ Angle setting can be seen on scale on top of the base plate.
9.3 Switch on and off (Fig. 6)
▪ Connect the battery pack (9) to the cordless jig saw and ensure it firmly.
▪ To switch on the jig saw, push the lock button (2) to and press the ON/OFF switch trigger
(3)
▪ When you release the switch trigger (3), the tool turns off.
