POWPB30400 EN
Copyright © 2021 VARO P a g e | 8 www.varo.com
8.2 Removal / insertion of battery (Fig. 2)
WARNING: Before making any adjustments ensure the machine is switched
off or remove the battery pack.
▪ Hold the tool with one hand and the battery pack (9) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
8.3 Battery capacity indicator (Fig. 3)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button (11). Before using the machine, please press switch
trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged
2 LED’s are litt: Battery 60% charged
1 LED is litt: Battery almost discharged
9 ASSEMBLY
9.1 Install or remove the saw blade (Fig 4)
WARNING: Before making any adjustments ensure the saw is switched off
with the lock-off button in the centre position and remove the battery from
the saw.
To avoid accidental start, check to make sure lock-off button is not engaged
prior to plugging in tool and you finger is not touching the on/off switch
trigger.
▪ Rotate the Quick-release blade clamp (2) anticlockwise with hand.
▪ At the same time push blade (7) to the deepest position, then release the quick-release
blade clamp (2). Make sure it is securely fastened.
▪ When removing the saw blade (7), follow the above procedure in reverse order.
WARNING! Before plugging in battery pack, always pull on the blade to
make sure it is securely locked in the clamp. Failure to do so may result in
serious injury.
10 OPERATION
10.1 Switch on/off (Fig. 5)
▪ Make sure the battery pack is installed.
▪ Push the lock-off button (4) towards left or right and squeeze the ON/OFF switch trigger
(5).
▪ To switch off simply release the ON/OFF switch trigger (5).
10.2 To change angle of the pivot shoe assembly (Fig. 6)
The pivot shoe assembly can be adjusted in a suitable angle by hand which is convenient for
operating this tool.
