Bedienungsanleitung Powerplus POWX0070LI (Seite 9 von 12) (Englisch)

644896

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

POWX0070LI EN

8.6 Speed selector (Fig 6)

NOTE： Mark “1”is Low speed position, mark “2” is High speed

position that moulding onto the button of two speed selector .

The drill has a two-speed gear train designed for drilling at 1 (LOW) or 2 (HIGH) speed. A gear

selector is located on top of the drill to select either low or high speed. When you push the

button forward and select low speed range, the speed will decrease but will provide more

power and torque. When using drill in the high speed range. Speed will increase but will

provide less power and torque. Use low speed for high power and torque application and high

speed for fast drilling applications.

Important: NEVER adjust this two speed selector whilst the drill is running.

Always let it come to a complete stop first.

8.7 LED light (Fig 7)

The LED work-light can light prior to motor running if you press the switch lightly, which keep

the work area to be lighted for checking clearly at first, and it lights also during your operation.

WARNING: Do not stare directly at the light beam. Never aim the beam at

any person or an object other than the work piece.

Do not deliberately aim the beam at personnel and ensure that it is not

directed towards the eye of a person for longer than 0.25s.

9 DRILLING

9.1 Drilling

Before use for drilling, the torque setting should be set on drill position “ ”.

When drilling hard smooth surface, use a center punch to mark the desired hole location. This

will prevent the drill bit from slipping off center as the hole is started. Hold the tool firmly and

place the tip of the drill or bit into the work piece, applying only enough pressure to keep the

bit cutting. Do not force or apply side pressure to elongate a hole.

9.2 Wood drilling

For maximum performance, use high speed steel bits for wood drilling. Turn the torque

adjustment ring on the drill to desired torque setting. Begin drilling at a very low speed to

prevent the bit from slipping off the starting point. Increase the speed as the drill bit bites into

the material. When drilling through holes, place a block of wood behind the workpiece to

prevent ragged or shintered edges on the back side of the hole.

9.3 Metal drilling

For maximum performance, use high speed steel bits for metal or steel drilling. Turn the

torque adjustment ring on the drill to desired torque setting. Begin drilling at a very low speed

to prevent the bit from slipping off the starting point. Maintain a speed and pressure which

allows cutting without overheating the bit.

Applying too much pressure will:

Overheat the drill

Wear the bearings

Bend or burn bits

Produce off-center or irregular shaped holes

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POWX0070LI Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POWX0070LI

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info