Bedienungsanleitung Powerplus POWX0077LI (Seite 6 von 10) (Englisch)

645094

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

POWX0077LI EN

 Do not cut nails or screws unless you are using a blade specifically designed for this

purpose. Inspect your material before cutting

 Before switching on the tool, be sure the blade in not contacting the work piece.

 Keep hands away from moving parts and on the top surface of the work piece. Do not

place hands below work surface while saw is operating.

7 ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES AND

CHARGERS

7.1 Batteries

 Never attempt to open for any reason.

 Do not store in locations where the temperature may exceed 40 °C.

 Charge only at ambient temperatures between 4 °C and 40 °C.

 Charge only using the charger provided with the tool.

 When disposing of batteries, follow the instructions given in the section “Protecting the

environment”.

 Do not cause short circuits. If connection is made between the positive (+) and negative (-)

terminal directly or via accidental contact with metallic objects, the battery is short circuited

and an intense current will flow causing heat generation which may lead to casing rupture

or fire.

 Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators

and other polymer components may be damaged resulting in electrolyte leakage and/or

internal short circuiting leading to heat generation causing rupture or file. Moreover do not

dispose of the batteries in fire, explosion and/or intense burning may result.

 Under extreme conditions, battery leakage may occur. When you notice liquid on the

battery, proceed as follows:

 Carefully wipe the liquid off using a cloth. Avoid skin contact.

 In case of skin or eye contact, follow the instructions below:

 Immediately rinse with water. Neutralize with a mild acid such as lemon juice or

vinegar.

 In case of eye contact, rinse abundantly with clean water for at least 10 minutes.

Consult a physician.

Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do

not incinerate the battery.

7.2 Chargers

 Use the charger provided with the tool only to charge the battery

 Never attempt to charge non-rechargeable batteries.

 Have defective cords replaced immediately.

 Do not expose to water.

 Do not open the charger.

 Do not probe the charger.

 The charger is intended for indoor use only.

8 ASSEMBLY

8.1 Install or remove the saw blade (Fig 1)

 Rotate the Quick-release blade clamp (2) anticlockwise with hand.

 At the same time push blade (7) to the deepest position, then release the quick-release

blade clamp (2). Make sure it is securely fastened.

 When removing the saw blade (7), follow the above procedure in reverse order.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POWX0077LI Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POWX0077LI

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info